What should fuel temp be for Honda Pilot?
COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature.
What should I know about the Honda Pilot Drive Cycle?
Following the Honda Pilot drive cycle below should allow the emission monitors to complete. The drive cycle must be followed accurately. Take extra caution when performing the drive cycle on public roadways. Perform the drive cycle at your own risk.
What do you need to know about OBD II drive cycle?
General Motors (specific) OBD II Drive Cycle. Performing a GM OBDII Driving cycle: Cold Start. In order to be classified as a cold start the engine coolant temperature must be below 122 F (50 C) and within 11 F (6 C) of the ambient air temperature at startup.
What should fuel temp be in Honda Odyssey?
Perform acceleration steps only on highways) COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature.
Following the Honda Pilot drive cycle below should allow the emission monitors to complete. The drive cycle must be followed accurately. Take extra caution when performing the drive cycle on public roadways. Perform the drive cycle at your own risk.
COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature.
General Motors (specific) OBD II Drive Cycle. Performing a GM OBDII Driving cycle: Cold Start. In order to be classified as a cold start the engine coolant temperature must be below 122 F (50 C) and within 11 F (6 C) of the ambient air temperature at startup.
How to decelerate a General Motors OBDII drive cycle?
Decelerate with using the brake [or the clutch!] by coasting down to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. General Motors (specific) OBD II Drive Cycle Performing a GM OBDII Driving cycle: Cold Start.