Can I repair a blower motor resistor?
The resistor module is easy and inexpensive to replace. It’s then typically installed in the ductwork, near the car blower—either under the dash or under the hood. (Refer to a service manual to locate yours.) Purchase a new resistor module at the auto parts store (usually less than $25).
Why is my Honda Fit AC fan not working?
The AC fan in 2009 Fits is faulty. It draws too much current and blows out the resistor pack. You could replace just the resistor pack and take your chances that the fan will continue to work for as long as you need it to, but there is no guarantee as to how long the replacement resistor pack will last.
How can I Fix my Honda Fit blower?
The unit is really easy to remove, just remove the glove box. Once it is out if you bang it on a hard surface a bunch of black dirt will come out of it. Either replace the blower or just clean it out with WD-40, then apply grease to the moving parts.
How much does it cost to fix a Honda Fit fan?
The fan had not been making any noises or having any other problems. I had the same issue. The Honda dealer verified that a service bulletin was issued and the recommended repair is to replace the blower fan and the resistor. I’m not a DIY’er so I had them do it to the tune of $466.99 (Parts, labor and tax).
Why is the blend door actuator on my Honda Fit not working?
The most common symptom of faulty blend door actuator on Honda Fit is a slight clicking sound repeatedly coming from under the dashboard. The sound will be most prominent for a few seconds when you turn on the air conditioning or adjust the temperature. Sometimes changing the temperature can temporarily stop the sound.
Why is my Honda Fit air conditioner not working?
The most common causes that hinders normal operation of air conditioning system on your Honda Fit are dirty cabin air filter, refrigerant leak, dirty or clogged condenser, dirty or clogged evaporator, bad blower motor, defective compressor, faulty blend door actuator or any fault in the electrical system. 1. Dirty cabin air filter
The unit is really easy to remove, just remove the glove box. Once it is out if you bang it on a hard surface a bunch of black dirt will come out of it. Either replace the blower or just clean it out with WD-40, then apply grease to the moving parts.
Why does my Honda Fit fan only work on high speed?
AC Fan only works on High Speed. New development:Have the same problem wit my Honda FIT 2011, a/c blower works three or four days then it quits, I leave it on and eventually it comes back on.Will wait for it to break down permanently , then I’ll fix it. Intermittent electrical problems bring out the magician trial and error troubleshooting.
The fan had not been making any noises or having any other problems. I had the same issue. The Honda dealer verified that a service bulletin was issued and the recommended repair is to replace the blower fan and the resistor. I’m not a DIY’er so I had them do it to the tune of $466.99 (Parts, labor and tax).