How do I set the time on my iHome hip9?
To Set Clock Manually a) Press and hold the Clock Adjust Button. The clock display will flash. b) Turn the Set Wheel until the current time is displayed (a PM indicator appears when time is set to PM; there is no AM indictor). c) Press the Clock Adjust Button to accept the time.
How do I set my iHome?
Press and Hold the Time Set Button located on the back of the unit until the display flashes. Press the – or + Buttons to adjust the clock to the current time (hold for rapid setting). Make sure you set the correct AM/PM time.
How do I reset my iHome alarm clock?
To do so, turn the unit ON and press the end of paperclip or similar into the reset port on the back of the unit for less than 2 seconds to reset it without clearing Bluetooth settings. The unit will reset and power back on. (If pressed for longer than 2 seconds, the unit will reset but will not power back on.)
How do I set the time on my iHome clock?
Press the – or + Buttons to adjust to the current date. Press the Time Set Button to confirm the date and exit clock setting mode. 2 beeps will confirm clock setting is complete.
How do I set the alarm on my iHome ipl8?
SETTING THE ALARM Press and hold the Alarm Button until the alarm time display flashes with one beep.
How do I turn off the alarm on my iHome docking station?
How to Turn Off the Alarm on an iHome
- Set the correct time on the iHome clock.
- Check the lower part of the clock display for the alarm time.
- Press the alarm button once to activate the alarm review mode.
- Press the alarm button once more during the alarm review mode to turn off the alarm.
Why is a battery flashing on my iHome?
The iP90 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup batteries.
How do I reset iHome ibt29?
The unit may need to be reset. To do so, unplug the unit from power source and remove the backup battery. Let unit stand for 2 minutes. Re-install backup battery and connect unit to power source.
How do I turn my iHome alarm off permanently?
Why does my iHome alarm keep going off?
The most common reason to this issue is a weak battery. This basically means that you have a weak battery that is turning off the devices randomly, especially when the song gets too loud.
How do I change the alarm sound on my Ihome?
Press the Presets Button to select an FM preset to wake to, or press the – or + Buttons to tune in a desired wake to station. Wake to Tone: Press the Alarm Button to confirm. Press the – or + Buttons to select the desired tone to wake to (Tone 1 -Tone 4).
How do I set the alarm on my Ihome zenergy?
Press and hold the Alarm Button until the alarm time display flashes and one beep sounds. Press the + or – Buttons to adjust the display to the desired alarm time (hold for rapid adjustment). Remember to set the correct AM or PM alarm time. 2.