Where is the valet button on a Viper alarm?
Typical locations for valet switch:
- Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness)
- Mounted in the driver’s side kick panel.
- Mounted in the steering column plastic housing.
- Behind a fuse block door or access panel.
- Low in the center console in the back of a pocket.
How do I turn off valet mode on Code Alarm?
To enter or exit valet mode simply follow the 4 steps outlined below: Turn the vehicle’s ignition ON. Push and hold the programming/valet button….To by-pass the alarm system:
- Open the vehicle door.
- Turn the ignition key to the ON position.
- Within 10 seconds, press and release the valet push button switch.
What is valet mode on alarm?
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational.
What is the valet button?
The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.
What is the valet button on Code alarm?
Valet Mode is used to temporarily prevent the alarm system from automatically disabling the vehicle starter (and ignition, if the optional vehicle immobilizer is connected), and stop the alarm from arming when the Automatic Arming option is enabled on your security system. This is useful when servicing your vehicle.
How do I know if my vehicle is in valet mode?
- Hold down the brake.
- Cycle the vehicle key in the ignition between the ‘On’ and ‘Off’ positions 5 times.
- Do not touch anything on the remote.
- You will know that you have entered valet mode if you see the parking lights flash one time and/or you hear a faint click from within the dash.
Where is the valet button on the Viper remote?
The valet button on the Viper 5701 is located on the antenna which is normally installed on the front windshield. Viper calls this button the “control button”.
What does it mean setting a valet car alarm?
The valet mode on a car alarm allows someone else to drive your car without having access to the security system. Valet mode is typically employed when you’re having your car parked or serviced. It enables you to maintain possession of your security remote. Locate the push button switch on your vehicle.
What is a valet override button?
Keeping this in view, what is the valet override button? The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system . To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.
Where is the valet switch?
The valet switch is usually located around the drivers side. Each installation is different, as are most alarms. The valet switch could be part of the flashing LED or, it could be incorporated into the on glass antenna. If not, it should be located below the driver side dash.