How do you remove the pulley bolt on a car?
It will likely require a 5/8″ socket and breaker bar to remove the engine pulley bolt. The engine will likely spin over while trying to loosen the bolt. To prevent the engine from spinning over, remove the spark plug and shove about 3-4 inches of cotton rope into the spark plug hole leaving a few inches exposed.
Can a pulley be removed from an engine?
Once you have removed the engine pulley bolt, the pulley should pull off the motor shaft. It will likely be stuck. I recommend spraying some rust penetration fluid at the top of the pulley and let it soak to help remove the pulley.
How to remove the engine pulley bolt on a craftsman lawn mower?
Craftsman Exclusives, Craftsman, Lawn Mowers, Lawn & Garden 1 Answer from this member: The engine pulley bolt is removed by turning it counterclockwise (CCW). It will likely require a 5/8″ socket and breaker bar to remove the engine pulley bolt.
It will likely require a 5/8″ socket and breaker bar to remove the engine pulley bolt. The engine will likely spin over while trying to loosen the bolt. To prevent the engine from spinning over, remove the spark plug and shove about 3-4 inches of cotton rope into the spark plug hole leaving a few inches exposed.
What’s the best way to install a pulley on a crankshaft?
Install special tool MB992278 and a box-type wrench at the optimum angle. 2. Rotate the pulley bolt of the auto-tensioner counterclockwise. 3.
Once you have removed the engine pulley bolt, the pulley should pull off the motor shaft. It will likely be stuck. I recommend spraying some rust penetration fluid at the top of the pulley and let it soak to help remove the pulley.
Craftsman Exclusives, Craftsman, Lawn Mowers, Lawn & Garden 1 Answer from this member: The engine pulley bolt is removed by turning it counterclockwise (CCW). It will likely require a 5/8″ socket and breaker bar to remove the engine pulley bolt.
How do you replace idler pulley on Maytag dryer?
Push the idler pulley to the right to release tension on the drive belt. Release the drive belt from the drive motor pulley and pull it out of the idler pulley. Pull the idler pulley out of the bracket in the base of the dryer. Install the idler pulley on the bracket at the base of the dryer and thread the drive belt through the new idler pulley.
What causes an idler pulley to come loose?
The idler pulley is mounted on a bracket. In some cases, the idler pulley is perfectly fine and the bearings are fully functional but the bracket on which it is mounted is warped or has come lose. These brackets can come lose due to excessive vibration which loosens the bolt which holds it in place.
What’s the best way to remove an idler pulley?
Use a ratchet and a socket or a hand wrench to turn the bolt head located in the center of the idler pulley counterclockwise. Remove the bolt and then remove the pulley.
How do you remove a bolt from a tensioner pulley?
The tensioner pulley has a smooth surface that the top of the belt — the side with no grooves — rides on. Put a socket on the bolt and turn the bolt counterclockwise to break it loose.
What do I need to replace idler pulley on Mercedes?
Use a flathead screwdriver to remove the dust cap on the center of the idler pulley. Do NOT discard the dust cap. It needs to be reinstalled. Use a T-50 Torx to remove the idler pulley bolt.
How do you remove a tension pulley on a Ford F-150?
To remove the belt, you will need a stretchy belt installer/remover. Insert your 1/2″ drive ratchet or belt removal tool into the hole on the tensioner. Rotate it clockwise towards the driver side to release tension. You can now release the tool and use both hands to remove the rest of the belt Figure 2.