How do you remove axle from Honda Civic?
Tie rod end disassembled. With all of the accessory hub items removed, remove the axle from the transmission. To do this, unbolt the hub from the axle by removing the cotter pin, and using an axle nut tool to remove the axle nut. This will free the axle from the hub side. From here, you have access to the inside of the axle.
Why are the axle seals leaking on my Honda Civic?
Most axle seals leak because they were not properly seated during installation. Fortunately, the repair is relatively simple. This article applies to the Honda Civic (1990-2000).
What happens when your front drive axle fails?
One afternoon, just as you pull out of the parking lot, there’s a loud banging noise and a series of crunches. Then all forward thrust drops off, punctuated by vibration and the occasional ping of tortured metal. Your CV joint has failed.
Which is the right side of the axle to replace?
And it’s usually the right side that goes first because here in the lefthand-drive US of A, we turn sharper around righthand corners than lefthand ones. Sometimes the rubber boots covering the joints fail from age or are torn by road debris, letting the grease out and dirt and water in.
What should I do if my Honda Civic axle seals are leaking?
Elevate the side of the car you’re working on with a hydraulic or hand jack. Place the jack stands underneath the car at the appropriate places, so the vehicle is secure. To remove the tire and wheel, first remove the lug nuts with an impact wrench or tire iron. Then you can remove the wheel and tire. Figure 1. Safely secure the vehicle on stands.
How to find a genuine Honda Civic axle shaft?
Enter your VIN for the most accurate results. Enter your VIN for the most accurate results. We offer a full selection of genuine Honda Civic Axle Shafts, engineered specifically to restore factory performance. Please narrow the Car Axle Shaft results by selecting the vehicle.
What are the symptoms of a bad CV axle?
1. Loud clicking noises when turning or accelerating. One of the most common and noticeable symptoms of a bad or failing CV axle shaft assembly is an audible clicking noise when turning or accelerating. When CV axles become excessively worn, the constant velocity joints will become loose and click when turning or accelerating.
Why is my CV axle failing on my Honda Civic?
If you notice a side-to-side shake when you accelerate, the inner CV joint is possibly failing. AutoZone has a great selection of axle replacements, so you can rest assured that you’re getting the right drive shaft for Honda Civic when you check out our extensive selection.
Where is the transmission seal on a Honda Civic?
Also known as the output shaft seal, this component is the most common source of the leak. The axle shaft seal is located between the axle and transmission. Here are the steps to diagnose: Raise the vehicle, and set it down on jack stands. Shine a flashlight through the chassis to where the axle shaft meets the transmission.
How do you fix axle seals on Honda Civic?
With the axle back in the transmission, press the axle back into the hub. Re-install the axle nut (torque spec is usually in excess of 120 ft/lb.) and cotter pin. Re-install the outer tie rod into the hub; this will help the hub be oriented in the correct direction to re-install the upper control arm.
Enter your VIN for the most accurate results. Enter your VIN for the most accurate results. We offer a full selection of genuine Honda Civic Axle Shafts, engineered specifically to restore factory performance. Please narrow the Car Axle Shaft results by selecting the vehicle.