Where is the oil pump on a Honda Accord?
The oil pump is an essential piece of equipment that keeps your Honda Accord running. It lubricates the engine by keeping the oil circulating. Without this lubrication, the engine wouldn’t run. An oil pump is usually located in the oil pan.
What’s the best way to replace an oil pump?
Step 1: Remove the oil pan. Remove the oil pan bolts and then remove the pan. On some vehicles you made need to remove other items first to access the pan, such as the the starter motor, exhaust pipe etc. Step 2: Remove the old oil pan gasket.
What to do if your Honda oil pump fails?
Remove the mounting bolts from around the pump. Unless you are certain the oil pump has failed, inspect the oil pump’s inner and outer rotor-to-radial clearance. Verify that they are between .02 to .16MM. Check the housing-to-rotor axial clearance and make sure it falls in between .02 to .07MM. Also, check for scoring on the pump assembly.
Where is the oil pump in a car?
It lubricates the engine by keeping the oil circulating. Without this lubrication, the engine wouldn’t run. An oil pump is usually located in the oil pan. If you want to change the oil pump and replace it with a new one, roll up your sleeves and get ready for some dirty work.
What to use to replace oil pump on Honda Accord?
Locate the outer ridges of the oil pump and apply the liquid gasket. Figure 10. RTV silicone is the preferred gasket material to use on mechanical components. Before threading the bolts into the block, apply a thread-lock compound. Replace the O-rings that mount in between the pump and engine block.
What’s the best way to install an oil pump?
Part 3 of 3: Install the pump. Step 1: Install the oil pump. To install the pump position it and the drive shaft extension. Engage the drive shaft extension into the drive gear. Then install the pump-to-rear bearing cap bolt and tighten to spec. Step 2: Install the oil pan. Clean the oil pan and install a new gasket.
Remove the mounting bolts from around the pump. Unless you are certain the oil pump has failed, inspect the oil pump’s inner and outer rotor-to-radial clearance. Verify that they are between .02 to .16MM. Check the housing-to-rotor axial clearance and make sure it falls in between .02 to .07MM. Also, check for scoring on the pump assembly.
Where can I get an oil pump replaced?
If you prefer to have someone get dirty for you, YourMechanic offers expert oil pump replacement at an affordable price. YourMechanic can replace your oil pump cover gasket or you O ring in the convenience of your own office or driveway.