How do you set the timing on a Honda Accord?
Turn the key ON and crank the engine. Using a feeler gauge to get close, adjust the points to the desired setting according to dwell readings and tighten the points. Crank it again to be sure the dwell angle is still correct. You can now go on to set your timing.
How do you set the points on a motorcycle?
Start with cylinder 1-4 for a 4 cylinder motorcycle. Remove the points cover. Start the engine. Aim the timing light through the points plate view hole. Confirm that the “F” mark aligns with the engine case’s timing mark at idle. Rev the engine to about 3,000 RPMs and confirm the parallel advance marks line up with the motorcycle’s timing mark.
How do you find the ignition point on a motorcycle?
You’ll want to find a position where the engine is not pinging under load or running too hot. Confirm your ignition timing is properly set with a timing light and by checking the color of your spark plugs. Turn the engine over until the points are at their widest opening point.
What happens when you set the ignition timing?
When you set your ignition timing, you’ll either retard or advance the spark. In general, low compression engines will need more of a spark advance than a high compression engine. As engines wear, they loose compression overtime, which is why it is important to regularly check and time your ignition to keep your engine in top shape.
Start with cylinder 1-4 for a 4 cylinder motorcycle. Remove the points cover. Start the engine. Aim the timing light through the points plate view hole. Confirm that the “F” mark aligns with the engine case’s timing mark at idle. Rev the engine to about 3,000 RPMs and confirm the parallel advance marks line up with the motorcycle’s timing mark.
When do you change the ignition points on a motorcycle?
The majority of motorcycles built before 1980 will have a points ignition. To ensure your spark stays strong and your engine runs well, you’ll need to inspect, reset, and change your points at normal intervals. If your points look worn, corroded, or pitted, you can replace them with a new set.
How do you check ignition timing on a motorcycle?
Confirm your ignition timing is properly set with a timing light and by checking the color of your spark plugs. Turn the engine over until the points are at their widest opening point. With a feeler gauge that matches the thickness of the point gap specified in your shop manual, measure the gap.
What should the timing be on a production engine?
A standard production engine has to run acceptably well over a wide range of operating conditions, poor fuel, towing of trailers/caravans etc. and yet still deliver good economy and flexibility. Consequently the engine is tuned to give good low down performance and will use conservative timing and fuelling settings.