What are the procedures in pulling out the clutch assembly from the engine?
Clutch Disc Hold the pressure plate securely and completely, then loosen the pressure plate-to-flywheel bolts by turning each bolt only a little at a time. Work in a criss-cross pattern until all spring pressure is relieved. Then remove the bolts, followed by the pressure plate and the clutch disc.
How do you remove a clutch from an Eaton car?
Remove the LCIB by unscrewing two nuts and sliding LCIB off of the input shaft. The two nuts that were removed should be retained for the installation of the new Low Capacity Inertia Brake. Note: Refer to CLSM0200 for clutch removal procedures. Shipping bolts must be used to properly remove the clutch.
Which is the correct way to install a new clutch?
Install the New Clutch: This part is very important! The clutch disc can go onto the pressure plate in either direction but only one direction is correct. The part of the disc that is protruding outward must go toward the pressure plate or the clutch will not release so it’s important to install the disc in the proper direction.
What to do if your clutch does not disengage?
Do not tighten any one bolt all at once and do not use air tools. This will bend the pressure plate and cause the clutch not to disengage. Work your way around the pressure plate slowly tightening several times until completely tight. You will notice the fingers of the pressure plate traveling inward as you tighten the bolts.
How do you replace a clutch disc on a car?
With the clutch disc loose position and install the clutch alignment tool into the clutch disc and pilot bearing. Slightly tighten the bolts further to hold the disc in place and move the tool in a circular motion.
Remove the LCIB by unscrewing two nuts and sliding LCIB off of the input shaft. The two nuts that were removed should be retained for the installation of the new Low Capacity Inertia Brake. Note: Refer to CLSM0200 for clutch removal procedures. Shipping bolts must be used to properly remove the clutch.
What should I do before replacing my Clutch?
There will be several subsequent guides that will need to be performed before the clutch can be replaced which are listed below: 1. Remove the Clutch: Once the above jobs have been done it’s time to inspect and remove the clutch pressure plate.
With the clutch disc loose position and install the clutch alignment tool into the clutch disc and pilot bearing. Slightly tighten the bolts further to hold the disc in place and move the tool in a circular motion.
How to remove manual clutch unit from Mazda 3?
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 4. Drain the manual transaxle oil.. 5. Disconnect and/or remove the following parts in the engine compartment.