How do you reprogram an adjustable bed remote?
Step 1: Unplug bed “A” and take the “A” remote and sync it to bed “B” Step 2: On the “A” remote press and hold the “head down” button and the “foot up” button at the same time for 10 seconds Step 3: Push the button on the side of the control box underneath bed “B” where it indicates reset coding.
How do you program a TempurPedic remote control?
How to program two remotes to a TempurPedic Ergo Bed
- Buy an extra remote, install batteries.
- Under the bed, press and hold the LEARN button on the control unit – hold this for 3 seconds.
- Now let off the button for about 1 second, then press (not hold) the button 2 times.
- Press any button on the new remote control.
How do I pair my Tempur Pedic ease remote?
Remote Pairing On the back of the remote, press and hold the PAIR button. The PAIR button will illuminate blue and start flashing. When the PAIR button stops flashing, the green LED light on the Control Box will go out. Release the PAIR button.
How do I pair my TempurPedic remote ease?
Locate the Control Box (see base overview and quick reference guide for corresponding base) and press the Reset/Pairing button twice. A pairing LED light will illuminate green on the Control Box. On the back of the remote, press and hold the PAIR button. The PAIR button will illuminate blue and start flashing.
How does a Tempur Pedic adjustable bed remote work?
The remote control that comes with the TEMPUR-PEDIC adjustable base is already programmed to operate the accompanying base without any additional setup. If you have replaced your remote or if your base does not function out of the box, follow setup procedures below to program your remote. Single base or two bases operating independently:
How do you program a Tempurpedic remote control?
To sync the remote with the base, hold the red button on the control box in for 5 seconds, at the same time, hit a button on the remote to turn it on. This will allow the remote to pair with the base. How much is a Tempurpedic adjustable bed? Tempur-Pedic Adjustable Beds Features and Prices
How do you connect two Tempur Pedic bases together?
Two bases operating in tandem by two remotes: Ensure two AA batteries have been inserted into each wireless remote control. Ensure both Tempur-Pedic bases are disconnected from power. Install connection cable by inserting one connector into each control box, pairing together both bases.
How to troubleshoot Tempur Pedic adjustable base power supply?
Press and hold the FLAT and STOP buttons simultaneously for at least 10-15 seconds. The current RF channel will be shown on the LCD screen. Press the FLAT button to confirm the RF channel number. The RF channel number will flash for 30 seconds. Within 30 seconds, reconnect the TEMPUR-PEDIC adjustable base power supply to a working outlet.