What size is the oil drain plug on a 2008 Honda Civic?
17mm
Dorman – Autograde – Oil Drain Plug Standard M14-1.50, Head Size 17mm (Part No. 090-033CD)
Where is the oil drain plug on a 2008 Honda Civic?
Locate the 17 mm hex oil drain plug at the back of the oil pan, facing the rear of the car.
What should I tighten for an oil change on a Honda Civic?
Once the oil has finished draining, tighten the drain plug and a brand new washer back on to the drain pan. If you have a torque wrench, the bolt should be tightened to 30 ft lb. or 40nm. Place the drain pan beneath the oil filter.
Where is the engine oil on a Honda Civic?
Honda made everyone’s life a little easier, and stamped the words “Engine Oil” on the oil pan with an arrow pointing to the drain plug. Position an oil drain pan under the oil pan so that it will collect the draining oil.
Where is the drain plug on a Honda Civic?
Locate the 17 mm hex oil drain plug at the back of the oil pan, facing the rear of the car. Honda made everyone’s life a little easier, and stamped the words “Engine Oil” on the oil pan with an arrow pointing to the drain plug.
How do you remove an oil filter on a Honda Civic?
Using the MX2330 oil filter wrench and a 3/8″ ratchet, remove the old oil filter by seating the wrench as far down the filter housing as you can and then ratcheting counter-clockwise. These filters can also be quite tight, so use the same steps as when you removed the drain bolt. Using Motivx oil filter wrench to loosen tight filter.
Where is the oil drain plug on a Honda Civic?
(Related Article: How to Jack Up Your Civic – Honda-Tech.com) Remove the oil cap on top of the engine. This will help the old oil to completely drain. Underneath the car (closer to the engine than the transmission) is a 17 mm hex oil drain plug, facing the rear of the car. Place the oil pan under this plug.
Once the oil has finished draining, tighten the drain plug and a brand new washer back on to the drain pan. If you have a torque wrench, the bolt should be tightened to 30 ft lb. or 40nm. Place the drain pan beneath the oil filter.
Using the MX2330 oil filter wrench and a 3/8″ ratchet, remove the old oil filter by seating the wrench as far down the filter housing as you can and then ratcheting counter-clockwise. These filters can also be quite tight, so use the same steps as when you removed the drain bolt. Using Motivx oil filter wrench to loosen tight filter.
How long does it take to get oil out of Honda Civic?
A nifty place to put your drain plug while waiting for the oil to drain. It may take 5 minutes or so to let the oil drain out. Make sure you get as much of that old oil out as you can. As you wait, clean the drain plug. Also take a rag or disposable wipes and clean any spots where oil may have splashed on the engine.