How do I reset my old Cisco router?

How do I reset my old Cisco router?

Reset Router Using Reset Button

1. With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
2. Find the Reset button on the router.
3. Press and hold the Reset button while you power on the router.
4. Release the Reset button after 10 seconds.

How do I clear all settings on a Cisco router?

Follow these steps:

1. Log on to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
2. Enter clear config all to reset the entire system. You don’t need to reload the switch because processing the command wipes the switch.

Is it possible to back up Cisco router configurations?

Cisco router products allow using TFTP (“Trivial File Transfer Protocol”) on a network server to read and write configuration files. Whenever a router configuration is changed, it is important to save the configuration file on the Linux server so that a backup is maintained.

How do I Reset my Cisco router to factory settings without a password?

How to: Resetting a Cisco Switch to Default & Password Recovery

1. Step 1: Connect the console cable to your PC.
2. Step 2: Verify that it is a console cable.
3. Step 3: Download Putty and Start a Serial Connection.
4. Step 4: Double Check Serial Settings.
5. Step 5: Plug in the Console cable.

How do I Reset my Cisco router 2800 to factory settings?

Method 2

1. xhut the router down.
2. Remove the compact flash from the back of the router.
3. Turn the router back on.
4. When you see the Rommon1> prompt, enter the command of confreg 0x2142.
5. Insert the compact flash.
6. Type reset.
7. When prompted to enter the initial configuration, type no and press enter.

Where is the reset button on a Cisco router?

Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

What command erase the startup configuration?

Enter config-register 0x2102. Enter end, and then enter the write erase command to delete the current startup configuration on the router.

How do I wipe my router clean?

How to Reset a Router

1. Keep your router plugged in.
2. Find your router’s reset button. This will be on the back or the bottom of your router.
3. Use a paperclip to hold down the reset button for 30 seconds.
4. Release the button.
5. Wait for the router to power back on.

How many ATM interfaces does a Cisco 1800 router have?

The Cisco 1811 and Cisco 1812 routers each have two Fast Ethernet interfaces for WAN connection. The Cisco 1801, Cisco 1802, and Cisco 1803 routers each have one ATM interface for WAN connection. Based on the router model you have, configure the WAN interface (s) using one of the following procedures:

How long does it take to reset a Cisco router?

Release the Reset button after 10 seconds. Wait 5 to 10 minutes for the router to finish booting. You can check the lights on the router — when the lights are solid or blink in repeating patterns, the router is finished booting. Power off your router.

How can I Reset my router to my default configuration?

Reset Router Using Router Commands. Connect your laptop to the console port on your router with the console cable. Power on the router and wait 5 to 10 minutes for the router to finish booting. You can check the lights on the router — when the lights are solid or blink in repeating patterns, the router is finished booting. On your laptop,…

What do I need to know about my Cisco router?

When you first boot up your Cisco router, some basic configuration has already been performed. All of the LAN and WAN interfaces have been created, console and VTY ports are configured, and the inside interface for Network Address Translation has been assigned.