Why does my car make a squeaky noise when I accelerate?
If you hear a chirping or squealing noise when you accelerate, it usually means a belt is loose and slipping or the drive pulley for an accessory has become misaligned.
Where to put the Jack on a 1998 Honda Accord?
This procedure is correct for all 1998-2002 Accord models equipped with the 2.3L inline 4-cylinder engine. Since the jacking location on the Accord isn’t large enough to fit both a jack and a jack stand, you must raise the car by placing the jack on the front subframe.
Why does my car squeak when I get in the car?
The squeaking noise when you get in, combine with your shop saying you need a new control arm sounds like the bushing on your control arm could be worn out causing a metal on metal sound when your suspension moves.
What to do if your Honda Accord has metal flakes in it?
Metal flakes in your oil could indicate a serious problem inside your engine. While the oil is draining, wipe down the drain plug with a clean rag or towel and remove the drain plug gasket. Replace the drain plug gasket with a new one, making sure that the new gasket fits over the threads and sits against the head of the bolt.
How to get an oil change on a 1998 Honda Accord?
Push down firmly on the hood to secure it in place. Allow 12-24 hours for all of the oil to drain out of the old oil filter. Take your old oil and filter to a recycling facility. Most auto parts stores and repair shops accept these at no charge to you.
Why does my Honda Accord make a squeaking noise?
If the noise is coming from your wheels, it’s possible that the wheel hubs and bearings are wearing out or about to wear out. To confirm that these are the cause of the noise, first you will need to jack the car up. Wiggle and rotate the wheel from side to side with some force.
The squeaking noise when you get in, combine with your shop saying you need a new control arm sounds like the bushing on your control arm could be worn out causing a metal on metal sound when your suspension moves.
Why does my power steering pump make a squeaking noise?
Some power steering pumps will work fine for a long time even if they make noise. The squeaking noise when you get in, combine with your shop saying you need a new control arm sounds like the bushing on your control arm could be worn out causing a metal on metal sound when your suspension moves.
Why does my Mazda Atenza make a squeaking noise?
The best way to check to see where the noise is coming from is squirt penetrating oil on each rubber bushing one by one and bounce the car in between. When the noise stops, you’ve found the culprit! Many Mazda Atenza owners have found the rear sway bar bushings to be the culprit so you might start there.