How do I setup a router for NanoStation?
Using Ethernet cables, connect the following:
- Connect the LRS gateway to the “Secondary” port on the router.
- Connect the “Main” port on the router to the “POE” port on the power adapter.
- Connect the “LAN” port on the power adapter to your internet source (optional)
How do I configure my NanoStation M5 as a router?
Connection
- Turn on Sphere PoE.
- Connect Sphere PoE jack to either NanoStation M5 Ethernet port (Primary or Secondary)
- Connect one of the remaining available Ethernet ports on the Sphere or the NanoStation to a local router / Internet-connected network.
How do I get to NanoStation settings?
Setting up the Nano and type in address bar: http://192.168.1.20 (the default address of the Nano) then press the Enter key. Type in ubnt twice and click OK → (If this window did not appear, there may be a problem with the wiring, the network card or a firewall).
What is the default username and password for Ubiquiti Unifi?
ubnt
Note: The default username is ubnt and the default password is ubnt.
What is UniFi NanoStation?
Indoor/Outdoor airMAX® CPE Featuring a panel antenna and dual-polarity performance, the NanoStation®M is ideal for Point-to-MultiPoint (PtMP) applications requiring high-performance CPE devices with a sleek form factor.
How do I manage my ubiquiti access point?
- Step 1a: connect the access point. Take the power cable and network cable for the access point.
- Step 1b: Connect with Power over Ethernet. Ubiquiti access points also all work via Power over Ethernet.
- Step 2: install the software. Open the download page of Ubiquiti in an internet browser.
- Step 3: set up the access point.
What is the default password for Ubiquiti access point?
ubnt / ubnt
As long as the UniFi Access Point has not been previously setup or adopted by the software, and only if you are attempting to connect via SSH, then always use the default username and password of ubnt / ubnt.
How to install an Ubiquiti Nanostation Ethernet router?
Installing your Ubiquiti Nanostation router 1 Remove the Ubiquiti Nanostation and the black POE (power over Ethernet) adapter from the box. 2 Plug the POE adapter in to a power source. 3 Using Ethernet cables, connect the following:
How can I Hard Reset my ubinquiti Nanostation?
If you do not know this, you can either hard reset it with a pin and use https://192.168.1.20 or the device discovery tools below to locate it for you. 2. Login to your Nanostation using a web browser address bar. If you forgot the username and password, you will have to hard reset the device anyway.
How to connect a LRS gateway to a Nanostation router?
1 Connect the LRS gateway to the “Secondary” port on the router. 2 Connect the “Main” port on the router to the “POE” port on the power adapter. 3 Connect the “LAN” port on the power adapter to your internet source (optional)
How can I connect my Nanostation M5 to the Internet?
Turn on Sphere PoE 2. Connect Sphere PoE jack to the NanoStation M5’s Secondary Ethernet port 3. Connect the Primary Ethernet port to an Internet-connected network if desired