Do you need to change timing belt and water pump?
If the cooling system contains original Honda coolant, a simple drain-and-fill with new Honda coolant is adequate. The valve cover must be removed or raised to remove the upper timing belt cover. A new valve cover gasket is highly recommended to avoid future gasket leaks.
When to replace timing belt on Acura RDX?
The timing belt system includes idler pulleys and a belt tensioner. These components should be replaced along with the belt. On some cars, the timing belt drives the engine’s water pump. Mechanics will usually recommend replacing the water pump at the same time that the timing belt is replaced.
How to remove the timing belt on a Honda Accord?
Remove the balance shaft belt. Remove the balance shaft center pulley (it is attached to the crankshaft and will slide off). Temporarily re-attach the balance shaft tensioner puller and hand tighten the tensioner bolt. Using needle nose or vice grip pliers, remove the timing belt tensioner pulley spring.
What kind of timing belt does an Acura CL have?
F23 Timing Belt Part Cross Reference Make Model Year Acura CL 1997–1999 Honda Accord DX, LX, EX 1994–2002 Honda Odyssey 1997 Isuzu Oasis 1998–1999
Should I replace the water pump at the same time as the timing belt?
If that is the case, then it is advisable to replace the water pump & auxiliary drive belt at the same time as the timing belt while the mechanic has access to all the parts. Once the timing belt is removed, it is only a matter of loosening a few more bolts and screws to change the water pump as well.
How often should the timing belt be replaced on a Honda Accord?
As per Honda, your timing belt needs to be serviced every 50,000 to 80,000 miles. While you’re in there, there are a few other important things to address like the timing balancer and the water pump. This article will guide you through the process of replacing the timing belt, timing balancer, and the water pump on your Accord.
How to remove timing belt and timing balancer?
Timing tensioner. Before moving on to the next step, it’s wise to drain the coolant. Place a pan under the car, and turn the petcock on the bottom of the radiator to release. Now that the coolant has been drained and the timing belt as well as the balancer have been removed, the water pump can come out. Remove the bolts in red (Figure 12).
Is the timing belt the same as the drive belt?
Note, the timing belt isn’t the same as the serpentine (‘drive’) belt, Autoblog explains. True, both are connected to the crankshaft. However, the former is located inside the engine, albeit by the outer wall. The latter is found externally, and drives many of the car’s accessories, like the alternator, power steering pump, and A/C pump.