Do you need tool to remove inner tie rod?
You don’t need any specialized equipment or tools for accomplishing this task. With a little bit of know-how and basic tools, you can remove the inner tie rod with much ease. Here are the steps you need to follow to remove the inner tie rod.
How do you remove inner tie rod from Honda Civic?
There are a few ways to remove the inner tie rod. You can use an inner tie rod tool, which can be rented from your local auto parts store. This is a special wrench that slides over the inner tie rod end and torques the ball joint.
How do you remove a tie rod from a steering wheel?
Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator. Insert the tool between the ball joint of the outer tie rod end and the steering knuckle. Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end.
How do you remove the tie rod from a cotter pin?
Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through. It holds the tie rod end to the steering knuckle. Removing it will allow you to remove the outer tie rod end. Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator.
What kind of tool do I need to remove inner tie rod?
A wrench, a ratchet set, needle nose pliers, mallet or hammer, grease gun and an inner tie rod tool are needed to remove the inner or outer tie rod ends from the steering knuckle or ball joint depending on which tie rod end. Go through the steps to remove then back through as you put the steering knuckle and tie rod ends back together.
There are a few ways to remove the inner tie rod. You can use an inner tie rod tool, which can be rented from your local auto parts store. This is a special wrench that slides over the inner tie rod end and torques the ball joint.
Is the inner tie rod removal set SAE or metric?
The inner tie rod removal set includes seven SAE and metric adapters to handle a variety of make and model vehicles. The set is constructed of forged steel and comes organized in a custom case for easy storage and transport. Not for “Saginaw”-type rack and pinion assemblies.
Where is the inner tie rod on a car?
The inner tie rod end is beneath the car at the end of the outer tie rod end. A wrench, a ratchet set, needle nose pliers, mallet or hammer, grease gun and an inner tie rod tool are needed to remove the inner or outer tie rod ends from the steering knuckle or ball joint depending on which tie rod end.