How do I know if my PerTronix ignitor is bad?
Check sticker on the backside of module “Ignitor by PerTronix” If the Sticker is shriveled up, wrinkled, cracked, or if you see any burn marks on that side of module the unit over heated and failed for various reasons. DO NOT USE SOLID CORE SPARK PLUG WIRES.
How do you troubleshoot a PerTronix Ignitor?
The best possible remedy for this problem is to wire the Ignitor units RED WIRE directly to a switched 12-volt source away from any voltage reduced circuit, such as a resister wire or ballast resistor. These circuits usually are in the wire from the ignition switch to the coil.
Does the timing have to be adjusted after installing a PerTronix Ignitor?
It should not require a timing change.
How do I test my PerTronix Ignitor?
Unplug the red Ignitor module wire. Connect the red Ignitor module lead to the battery positive terminal using a jumper wire if required. Attach the black lead of the multimeter to the Ignitor module black wire. Attach the red lead of the multimeter to the battery positive terminal.
Who owns PerTronix?
The AAM Group
PerTronix – The AAM Group.
How do you test a PerTronix flamethrower coil?
What should I do if my pertronix Ignitor is not working?
The best possible remedy for this problem is to wire the Ignitor units RED WIRE directly to a switched 12-volt source away from any voltage reduced circuit, such as a resister wire or ballast resistor. These circuits usually are in the wire from the ignition switch to the coil.
Why is my pertronix coil turning off and back on?
The unit is actually turning off, and back on as the coil charges and releases energy. The best possible remedy for this problem is to wire the Ignitor units RED WIRE directly to a switched 12-volt source away from any voltage reduced circuit, such as a resister wire or ballast resistor.
Why do I have problems with my ignitor?
Apparently these units are very sensitive to poor earthing. They say 99.9% of problems experienced by Ignitor users are down to one of the above – otherwise they are a very reliable unit. So if you are having problems with an Ignitor set-up, make sure all the aforementioned are checked before returning the kit for testing.
What are the applications covered with the pertronix flame thrower coils?
What applications are covered with the Pertronix Flame-Thrower coils? Our Flame-Thrower coils are designed specifically for compatibility with our Ignitor 1, 2 and 3 units. However, the Flame-Thrower 1 Coil may also be used with a point type system or any other system that calls for a 1.5 or 3.0-ohm coil.