How do you program a key for a 2005 Honda Pilot?

How do you program a key for a 2005 Honda Pilot?

2005 Honda Pilot Remote Programming

1. Turn ignition switch to ON (II)
2. Press the LOCK or UNLOCK button on one of the remotes.
3. Turn ignition switch to ACCESSORY (I) or LOCK (O)
4. Turn ignition switch to ON (II)
5. Press the LOCK or UNLOCK button on one of the remotes.
6. Turn ignition switch to ACCESSORY (I) or LOCK (O)

What should I know about the Honda Pilot Drive Cycle?

Following the Honda Pilot drive cycle below should allow the emission monitors to complete. The drive cycle must be followed accurately. Take extra caution when performing the drive cycle on public roadways. Perform the drive cycle at your own risk.

When to replace timing belt on Honda Pilot?

Hardlymoving writes about do-it-yourself automobile maintenance on various makes and models. This article shows you, in a video and with written instructions, the replacement of the timing belt, water pump, tensioner and guide pulleys on the 2005 – 2015 Honda Pilot like this one. The service interval is 105,000 miles or 7 years.

What should fuel temp be for Honda Pilot?

COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature.

Where is the tensioner pulley on a Honda Pilot?

The tensioner pulley is above the guide pulley. Apply counter-clockwise torque to the center 14-mm tensioner pulley bolt to relieve tension on the belt. (This optional step can be performed now or later).

Hardlymoving writes about do-it-yourself automobile maintenance on various makes and models. This article shows you, in a video and with written instructions, the replacement of the timing belt, water pump, tensioner and guide pulleys on the 2005 – 2015 Honda Pilot like this one. The service interval is 105,000 miles or 7 years.

The tensioner pulley is above the guide pulley. Apply counter-clockwise torque to the center 14-mm tensioner pulley bolt to relieve tension on the belt. (This optional step can be performed now or later).

What do you need to replace Honda impact driver?

Replacement parts and service steps, with minor variations, may also be applied to other Honda and Acura vehicles as follows: Special tools needed: a Honda 19 mm (crankshaft pulley / harmonic balancer) impact socket used with a powered impact driver like this one. See photos of this special socket below.

How to remove a water pump from a Honda Accord?

Remove the five 10 mm-bolts that hold the water pump to the engine. Remove the pump. A small pry bar or screwdriver can help break the seal between the pump and engine. Make sure the O-ring is removed with the water pump. Clean contact surfaces with a wire brush. VII. Installing the Water Pump