What is the new transmission pressure switch number?
4th switch or 28600-RAY-003 = 28600-RAY-013, which has now been replaced by 28600-RKE-004. Can somebody please verify that the new part numbers are correct cross references to the old originals?
Where is the transmission oil pressure switch located?
The transmission oil pressure switch is attached to the transmission case and was engineered to monitor and relay the oil pressure inside the transmission to the on board computer found in most vehicles. Older vehicles without ECM also utilize a transmission oil pressure switch,…
What are the symptoms of a bad transmission oil pressure switch?
Common signs include the vehicle entering “limp” mode, having difficulty shifting, and its engine RPM being higher than it should be. What is the transmission oil pressure switch? 1. Vehicle enters “limp” mode 2. Vehicle has difficulty shifting 3. Engine RPM is higher than it should be
What is the function of the transmission oil pressure sensor?
The transmission oil pressure sensor’s primary function is to relay information to the ECM that regulates control of the transmission.
4th switch or 28600-RAY-003 = 28600-RAY-013, which has now been replaced by 28600-RKE-004. Can somebody please verify that the new part numbers are correct cross references to the old originals?
Where to get transmission oil switch for Honda Pilot ex?
For my 2005 Honda Pilot EX, I ordered my 4th and 3rd transmission oil switches from hondapartswholesaledirect.com (Colonial Honda in MA). Richard from parts department indicated that the new Part numbers are:
Where is the 3rd gear switch on a 2005 Honda?
I just passed 203,000 on my 2005. I will keep you posted if it helped the shuddering. The 3rd gear switch (28610-RAY-003) is right behind a plastic shroud. 4th gear (28600-RAY-003) is right above it and has a 4 stamped on it
How to replace transmission pressure switches in Honda?
FYI: just pop in and report, code P0847 on torque OBD2 ( transmission fluid B sensor) . I order both 28610-R36-004 and 28600-R97-003 ( $36/EA) . Replaced 28610-R36-004 by remove lower plastic and remove sensor – (#12 in the picture) 22mm wrench clear the code by disc. the battery terminal …. Recheck all clear today.
For my 2005 Honda Pilot EX, I ordered my 4th and 3rd transmission oil switches from hondapartswholesaledirect.com (Colonial Honda in MA). Richard from parts department indicated that the new Part numbers are:
I just passed 203,000 on my 2005. I will keep you posted if it helped the shuddering. The 3rd gear switch (28610-RAY-003) is right behind a plastic shroud. 4th gear (28600-RAY-003) is right above it and has a 4 stamped on it
FYI: just pop in and report, code P0847 on torque OBD2 ( transmission fluid B sensor) . I order both 28610-R36-004 and 28600-R97-003 ( $36/EA) . Replaced 28610-R36-004 by remove lower plastic and remove sensor – (#12 in the picture) 22mm wrench clear the code by disc. the battery terminal …. Recheck all clear today.
Where can I get transmission oil switch replaced?
Switches found on Amazon for $30 a pop. For my 2005 Honda Pilot EX, I ordered my 4th and 3rd transmission oil switches from hondapartswholesaledirect.com (Colonial Honda in MA). Richard from parts department indicated that the new Part numbers are: 4th switch or 28600-RAY-003 = 28600-RAY-013, which has now been replaced by 28600-RKE-004.
Where is the transmission fluid pressure switch located?
The Transmission Fluid Pressure Sensor /Switch (TFPS) is usually found attached to the side of the valve body inside the transmission, although sometimes it may be found screwed into the side of the transmission case/body itself.
What is a third clutch pressure switch?
The 3rd clutch transmission fluid pressure switch is installed in the hydraulic pressure circuit to the 3rd clutch. When hydraulic pressure is supplied to the 3rd clutch, the switch is turned ON. When hydraulic pressure is not supplied to the 3rd clutch, the switch is turned OFF.
What does a transmission pressure sensor do?
The transmission sensor performs contactless scanning of the steel or multipole trigger wheels. The sensing element of the transmission pressure sensor consists of a membrane that is deformed by the applied pressure. The deformation is converted into a voltage proportional to the pressure.