How does a sway bar link work on a car?
The sway bar link is a component that attaches the sway bar to the lower control arm — the lowermost suspension arm. The lower control arm keeps the sway bar straight, while rubber bushings allow flex for ride comfort. If you are looking for optimum performance, however, you can tighten your sway bar using aftermarket sway bar link bushings.
How do you change the bushing on a sway bar?
Place the new bushing onto the sway bar in the same fashion. Since they’re new, they’re going to be even more stubborn than the old one(s). Position the bushing back in the correct location on the sway bar and replace the brackets. Tighten with the ratchet, socket and hand wrench as necessary.
How is a sway bar attached to a suspension arm?
The sway bar link is a component that attaches the sway bar to the lower control arm — the lowermost suspension arm. The lower control arm keeps the sway bar straight, while rubber bushings allow flex for ride comfort.
How much does it cost to replace a sway bar?
Typically, a car requires new sway bar end links or stabilizer bushings. A replacement sway bar end link will cost between $125 and $160, with labor making up $50 to $70 and the part costing between $55 and $110. The stabilizer bushing replacement cost is between $125 and $160, with labor making up $95 to $120 and the part costing $30 to $65.
How to replace front sway bar bushing and links?
This shows the new passenger side frame bushing on a 2001 GMC Jimmy. Lightly grease the bar, bushings, and mounts. Slide the bushing over the bar and cover it with the mount. Position and reattach the mount. Torque the nuts/bolts to specification. Grease as required.
What are the links on a sway bar?
Be sure it is installed the same as the original – the bushings are touching the sway bar – from the top: nut, metal washer, bushing, sway bar, bushing, metal washer. The lower link is simply nut, mounting point, smaller nut.
What do I need to remove front wheel drive sway bar?
Remove the nuts holding the sway bar link to the bar and control arm. Remove the link. Link removal on some front-wheel-drive cars will require a ΒΌ-inch Allen wrench to keep the bolt from spinning.
Can you remove the nut from a sway bar?
Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.