What is WAN connection error?

What is WAN connection error?

If you see a red message “WAN Port is unplugged” on the status page of the router,that means the modem is NOT plugged into the WAN Port of the router properly. Please plug it in and make sure the red message will be gone. Solution 2：Clone the MAC address of your PC.

Can’t connect to Tenda wireless router?

You can try solutions as below.

1. Power cycle your modem and the Tenda device.
2. Change the LAN IP address in the setup page.
3. Clone the MAC address.
4. Change the DNS Address.
5. Change the MTU value.
6. Change the WAN speed in setup page.
7. Reset the Tenda device to factory default.
8. Upgrade to a newer firmware.

How do I connect wan to Tenda?

Steps are as following:

1. 1.1 Login to the management page of the router.
2. 3.1 Click Advanced and then choose WAN Medium Type, choose Wireless WAN, Click Open Scan.
3. 3.2 Select the Router1’s SSID, and input the router1’s security key.

How can I fix my Tenda WiFi router?

How do you fix your WAN connection is down?

To troubleshoot your WAN or LAN port:

1. Plug in the power adapter of your router to the power outlet.
2. Turn on the router and wait for the power LED to become solid green or white.
3. Take one Ethernet cable, and connect one end to any of the router’s LAN port, and the other end to the router’s WAN port.
4. Check the LEDs.

How do I get WAN connection?

Insert your wireless router’s AC adapter to the DC-IN port and plug it to a power outlet. Use another network cable, connect your modem to your wireless router’s WAN port. Use the bundled network cable, connect your computer to your wireless router’s LAN port.

How do I know if my hardware is connected to WAN port?

How do I change my 192.168 0.1 password Tenda?

Step 1: Login the homepage.

1. Open a browser then type “192.168. 0.1” into the Address Bar, press Enter.
2. Then the interface will turn into the homepage, tap “Wireless Settings”, change your SSID and password in this page, and tap “OK”.
3. The notice window would be shown on the top.

How can I connect Tenda router without password?

Note: The default password is shown on the bottom of the router. If you have changed it and you also forgot it, see “Forget your password?” below the “Login” button. 2. Then the interface will turn into the homepage, tap “Wireless Settings”, change your SSID and password in this page, and tap “OK”.

Why is the wan light not on?

The WAN Light on my D-Link Router is not illuminated Verify that the Ethernet cable connection to the wall outlet is secure. Verify that the Ethernet cable connection to the WAN port on your router is secure. Recheck to see if the WAN light is lit.

Should I disable Ping Wan?

Ping may make your IP exposed to hackers’ attack. Hackers usually scan the IP addresses from the internet before launching attack. Thus, set to ignore Ping Packets from WAN Port can hide our devices from hackers’ targets.