How long does it take to replace clutch on civic?
I can do this particular car in around 3-4 hours if I don’t get distracted. Realistically, you should give yourself 8-10 hours of actual work time plus whatever you spend fixing as you go. There are probably several different ways to approach this kind of work depending on the equipment available to you.
Do you need wheel chocks for Honda Civic?
Wheel chocks are not optional. If the car rolls and falls off of the jackstands onto you, you will die. Use a hydraulic jack rated for at least twice the full weight of the car. (1.5 tons X 2) – Cardboard to work on. Get several sheets.
What are the sockets on a Honda Civic?
– Sockets and extensions. Regular sockets: 12,14,17,19. Deep sockets: 10,12,14,17,19,21. 12-point sockets: 10,17. Short and long extensions. The 21mm deep socket is for the wheels, you can use the tire tool in the trunk. The 10mm and 17mm 12-point sockets are required to remove the pressure plate and flywheel bolts.
How big should the flywheel be on a Honda Civic?
You can try to have the flywheel resurfaced but getting it done correctly is a crapshoot. If you have a local shop that does flywheel resurfacing, you’re better off to try to sell them your old flywheel and then buy a brand new one. The flywheel should weigh at least 15 lbs or it will cause a check engine light.
How to replace clutch on Honda Civic Si?
Get a box of exam gloves and change them often. Also, get some steel wool or scotchbrite pads, some penetrating oil, a steel brush, and several cans of brake parts cleaner. – Thick blanket. Like a furniture blanket. You’ll have the transmission in your lap and this will save your legs.
How do you replace the flywheel on a Honda Civic?
Use the following steps to replace the flywheel and clutch on your Honda Civic. The quickest way to reach the clutch is from underneath the chassis. In order to do this, use a jack to raise the vehicle and a pair of jack stands to support the chassis in the air. Also use this as an opportunity to drain the transmission fluid. Figure 1.
Wheel chocks are not optional. If the car rolls and falls off of the jackstands onto you, you will die. Use a hydraulic jack rated for at least twice the full weight of the car. (1.5 tons X 2) – Cardboard to work on. Get several sheets.
Where are the transmission bolts on a Honda Civic?
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.