Why does my Honda bike have no lights?
Or maybe your problem with no lights and priming the fuel pump etc when you turn the key happend before your battery went dead… after all the battery must have died for a reason… If all your fuses are good you may have fried your ECM, wire harness, or selanoids.
What causes no ignition, or dash lights when turning key?
Q: I have no ignition, or dash lights when turning key. All relays and battery are fine. Dash lights work when headlights are on. I’m thinking its some kind of electrical problem. I got it to start one time with the remote start. After that, nothing. I’ve tried jump box to be sure I have power.
What to do if your bike ignition is not working?
If the engine isn’t running and the rest of the electrics are dead I’d first check the connector from the generator to the rest of the wiring and also the connector to the ignition switch, and then the ignition switch itself. As the other guy said, you may need a multimeter to do this properly.
Why are the dash lights not working on my car?
All relays and battery are fine. Dash lights work when headlights are on. I’m thinking its some kind of electrical problem. I got it to start one time with the remote start. After that, nothing. I’ve tried jump box to be sure I have power. All electronic systems work except the dash lights, and ignition.
Or maybe your problem with no lights and priming the fuel pump etc when you turn the key happend before your battery went dead… after all the battery must have died for a reason… If all your fuses are good you may have fried your ECM, wire harness, or selanoids.
Why does my Honda Pilot not start up?
Honda Pilot won’t start again. Completely dead. Possibly anti theft? turn it on and nothing happened. No lights or anything. Didn’t even click. The lock buttons would not work either. Weird cause my lights had been off battery before, always starts right away.
What are the fuses on a Honda bike?
The main fuse is a 30amp… the rest of the fuses in the main block are 5,10,15 etc… if you hooked up to jump the bike to the running car engine you could have sent a small enough surge to not trip the main fuse… but enough to trip the smaller fuses in the main block… check all those fuses.
Why are my high beam headlights not working?
In the case of high-intensity discharge (HID) headlights, or Xenon headlights, there’s an additional component. To get the xenon and salts to plasma state, the HID generator bumps the voltage up to 30,000 V, then stabilizes around 90 V when the bulb is in operation. If the generator fails, the bulb won’t light.
What should I do if my headlight bulb fails?
If you have multiple headlight bulb failures, make sure you are especially clean when doing the job. If at all possible, don’t touch the glass portion of the bulb at all. If necessary, handle the bulb with clean latex or nitrile gloves. Finally, if the bulb is dirty, clean it with a fresh alcohol pad before installation.
Why are the lights flickering on my Honda Accord?
The lights flicker, the dashboard lights up, and the stereo works, but the only thing that happens when you turn the key is a clinking sound. If you can’t figure out why your car is acting this way, then continue reading. This article applies to the Honda Accord (1990-2002).
What should I do if my headlight light is not working?
The best way to do this is to turn the headlight switch on, connect the negative lead on your meter to a known good ground, and touch the positive lead to each headlight connector terminal. One of the terminals should show battery voltage, and the other two should show nothing if the problem is burned out bulbs.
What happens when you turn on the headlights?
When you turn on your headlights, that switch activates a relay. That relay, in turn, actually provides the electrical connection between your headlight bulbs and the battery. Fuses are also involved in order to provide a sacrificial failure point to protect the rest of the wiring.
Why are my headlights not working in high beam?
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
What to do if your HID light bulb is not working?
The easiest way to verify that your HID headlight capsule is bad is to carefully remove both bulbs and replace the one that doesn’t work with the one that does. If the known-good bulb fails to turn on when placed in the other socket, then you’re dealing with a more complicated issue.
The main fuse is a 30amp… the rest of the fuses in the main block are 5,10,15 etc… if you hooked up to jump the bike to the running car engine you could have sent a small enough surge to not trip the main fuse… but enough to trip the smaller fuses in the main block… check all those fuses.
Is the electrical system on my Honda Odyssey dead?
The electrical system went completely dead on my 2004 Odyssey. The flights flicker off and on. The auxiliary key position won’t let me … read more My 2009 Honda Pilot won’t start, the door locks aren’t working. It’s like the battery is dead but I checked it and it’s fully charged. The entire … read more I have a 2015 Honda Odyssey.
Why does my ATV have no power when I turn the key?
When I installed the new battery, I didn’t noticed that there were two positive cables that need to be connected to the positive terminal. One of them had slipped back into the boot, and I only connected the other one. This is why the ATV had no power at all when I was turning the key.
What to do if a headlight fuse keeps blowing out?
Headlight Fuse Keeps Blowing Out. If you keep blowing a headlight fuse, give these simple steps a try. Unplug the light, pull the switch, and see if the fuse blows. If not, the problem is not in the wiring. Make sure you have purchased the correct wattage of bulb. Ensure that you do not have a faulty or damaged bulb.
Why is my motorcycle headlight not working properly?
Problems with motorcycle headlights can be caused by a range of issues, including faulty wiring, bulbs and connectors. Troubleshoot a motorcycle headlight in order to narrow down the possible cause of the headlight malfunction.
What are the symptoms of a blown fuse on a motorcycle?
Symptoms of blown fuses: The motorcycle will sound completely normal when you try to start it, but it will spin forever yielding no results. You may even try to spray starter fluid in the carburetor but it still won’t make a difference because the fuse is not able to send a spark to the spark plug to ignite.
Problems with motorcycle headlights can be caused by a range of issues, including faulty wiring, bulbs and connectors. Troubleshoot a motorcycle headlight in order to narrow down the possible cause of the headlight malfunction.
What to do if your bike won’t start?
1) Place Bike in NEUTRAL. 2) Remove the fuse cover and locate the start Relay. It is the GRAY one. On the inside cover there is a label that will identify the START Relay. 4) Look at the bottom of the removed gray relay closely. You will see pin notation as follows. 87,,87A,,30,,85,,86. 5) Leave the relay REMOVED from the bike.
What to do when both head lights stop working at the same time?
When that happens, the operational lifespan of your headlight capsule will be severely compromised, and the only fix is to replace the headlight assembly. When both headlights stop working at the same time, the bulbs usually aren’t at fault.
Is the battery on my Honda ATV working?
Battery is installed yesterday, nothing working, nothing with starter button, no neutral, oil, lights with ignition on.. Relay appears fine.
Is there a neutral switch on a Honda ATV?
Turn key on, no indicator lights such as the green neutral, no headlights. All worked last fall when put away for the winter. Can jump the starter from the solenoid. All fuses are fine. Schematic shows a ‘main fuse’, but can’t find it if there is one. Schematic also shows a ‘neutral switch’ which I also can’t find. Help!
How can I tell if my bike has no power?
While the bike was spluttering the neutral and indicator light dimmed on and off and looked as if it ran out of electricity. After it stopped running I turned the ignition on and off and there was no power to the lights at all. The neutral, indicator, brake and head lights do not work, no power at all.
Battery is installed yesterday, nothing working, nothing with starter button, no neutral, oil, lights with ignition on.. Relay appears fine.
Why are there no lights on my Honda ATV?
Another odd thing is when I would turn on the key it would take a 10-15 seconds for the neutral light to come on and sometimes it would be very dim. It almost acts like loose connection or a switch that’s not operating correctly, but I have been unable to find either.
Turn key on, no indicator lights such as the green neutral, no headlights. All worked last fall when put away for the winter. Can jump the starter from the solenoid. All fuses are fine. Schematic shows a ‘main fuse’, but can’t find it if there is one. Schematic also shows a ‘neutral switch’ which I also can’t find. Help!
Are there lights on the dash of a Honda?
I still have no lights on the dash nor does the starter button engage the start. Battery is good and I can short across the starter solenoid and it spins the starter. I forgot to mention earlier that I installed an aftermarket key switch 2 years ago.
What does it mean when a VW battery wont start?
First, you want to find out if the immobilizer is the problem. To do this, turn on the battery in your Volkswagen and see if the immobilizer warning light is flashing on your dash, most likely in your speedometer. It should look like an outline of a car with a key inside it. If it’s flashing, it means the immobilizer’s disconnected from the system.
Why does my Mercedes not start when I charge the battery?
This Mercedes-Benz is not starting because of a low battery. In this case, what you need to do is trickle charge your battery using any of these 12 volt battery trickle chargers. If you need help read this article on How to charge a Mercedes-Benz the right way. Mercedes won’t start, and it’s not the battery.
What does it mean when your car won’t start?
There is the scenario where the engine spins over nicely but refuses to start. Here we’re going to talk about the second group, which is when a classic car won’t crank over at all. Mechanics refer to this as a no crank no start condition. Of course, the number one reason for an engine not the crank on any car would be a problem with the battery.
What to do if no power to ignition or headlights?
And its the only thing left on the checklist that is in line to power the solenoid and headlights. Purchased an aftermarket ignition and spliced it in place of the old ignition switch. A starter relay was inexpensive so I purchased one just in case. I put the old starter relay back into the plug.
What causes a car to have a no start condition?
The battery or battery problems are the number-one cause of this type of no-start condition. A quick way to check your battery is to turn your headlights on. If the headlights come on and are nice and bright, not dim or dull, then it’s likely your battery and its connections are okay.
First, you want to find out if the immobilizer is the problem. To do this, turn on the battery in your Volkswagen and see if the immobilizer warning light is flashing on your dash, most likely in your speedometer. It should look like an outline of a car with a key inside it. If it’s flashing, it means the immobilizer’s disconnected from the system.
Why does my Harley Davidson have no power?
Last Friday I shut the motor off with the stop switch and then turned the ignition key off. I re-set the stop switch to On. 1 minute later, I turned the ignition switch to ignition and noticed I had no power to my headlights and instrument lights.