How can I diagnose a Honda transmission problem?

A scanner that can diagnose Honda transmission problems. Here are a few popular choices. These scanners can read and clear fault codes from the transmission module. Locate the OBD-II port under the dashboard. Turn on the ignition. Allow your scanner to turn on. Select your Honda model, then go to the Control Unit.

When does the Check Engine light come on in a Honda?

This article applies to the Honda Civic (1992-2000), and Accord (1990-2002). The check engine light in your Honda offers important diagnostic information, which will alert you of a serious problem like a bad catalytic converter. However, the check engine light also appears when the fuel tank cap is loose, or a change in humidity has occurred.

What is the fault code for a Honda transmission?

While there are hundreds of possible fault codes, here is a list of the most common Honda transmission fault codes. P0766 “ Failed Shift Solenoid D “ This DTC can be stored when there is a problem with a shift solenoid or the valve body.

What causes Honda transmission to go into limp mode?

If you have a scanner designed for Honda, it is good to perform a full system scan that will read codes in all modules. Sometimes a problem with the mass airflow sensor, Powertrain Control Module PCM, or VSS can cause your transmission not to shift, shift erratically, or go into limp mode.

When does the check transmission light come on?

As of 2012, most new vehicles have a warning light that lets you know of transmission problems before they become a major expense.

How to tell if your Honda transmission is low on fluid?

Signs that your Honda transmission may be low on the transmission fluid include delayed engagement, transmission slipping, and rough shifts between gears. Drive your Honda for 15 min to warm up the transmission fluid, then park it on level ground.

What should I do if my Honda check engine light is not working?

Check to see that all electronics in the vehicle are working properly (e.g. dash light, 12-volt power supply, interior lights). If everything is working properly, I would either test all the fuses (using a test light or a voltage meter is the fastest way to do that) or return the vehicle to the person who did the work. 5.

What are the symptoms of a bad transmission speed sensor?

Symptoms of a Bad or Failing Transmission Speed Sensor. 1 1. Harsh or Improper Shifting. Without a valid speed signal from these sensors, the PCM will not be able to correctly control the shifting of gears 2 2. Cruise Control Does Not Work. 3 3. Check Engine Light Comes On.

What is the code for the Honda check engine light?

A long flash (or approximately one second) equals 10. A short code (or approximately half a second) equals one. For example, two long flashes followed by two short flashes will equal to the code 22. Any subsequent codes will follow in 2.5 second intervals.

Navigation