What should the fuel pressure be to start a Vortec engine?
The fuel system in your 4.3L, 5.0L, or 5.7L Vortec engine needs at least 50 PSI of fuel pressure to start. The fuel pump produces much more than just 50 PSI of course but the bare minimum the engine needs to start is 50 PSI… so anything less and it will crank for ever before it starts or not start at all.
How much psi does a fuel pump need to start?
The fuel pump produces much more than just 50 PSI of course.. but the bare minimum the engine needs to start is 50 PSI… so anything less and it will crank for ever before it starts or not start at all.
What should the fuel pressure be on a Chevy Cheyenne?
93 Chevy Cheyenne k3500, if it is running the Chevy vortec engine the fuel pump pressure is way too low, should be 56 psi+ depending on CSFI/CPI system or it will not start or open injectors, with out the aid of starting fluid. The factory manual specifies that the fuel pressure for the CSFI system should be between 56-62 PSI.
Where is the throttle body fuel pump located?
As you’re already aware, the throttle body fuel injection system on your 1987 to 1995 4.3L, 5.0L, or 5.7L pickup (or SUV) uses a low pressure (12 PSI) electric fuel pump located in the gas tank.
93 Chevy Cheyenne k3500, if it is running the Chevy vortec engine the fuel pump pressure is way too low, should be 56 psi+ depending on CSFI/CPI system or it will not start or open injectors, with out the aid of starting fluid. The factory manual specifies that the fuel pressure for the CSFI system should be between 56-62 PSI.
As you’re already aware, the throttle body fuel injection system on your 1987 to 1995 4.3L, 5.0L, or 5.7L pickup (or SUV) uses a low pressure (12 PSI) electric fuel pump located in the gas tank.
What should the fuel pressure be on a TBI 350?
WRONG – tbi is 11 to 14 lbs pressure stock! A stock tbi injector can go up to about 30 psi though:flipoff2: TBI’s max out around 30 psi, operating pressures are lower. Pressures in the 50-70 range are common in the later model CSFI & CPI vortec engines.
Where to spray starting fluid on GM TBI fuel system?
Spray starting fluid down the bore of the throttle body. When you have sprayed a good squirt of starting fluid, quickly place the air filter assembly’s cover back on. IMPORTANT: Placing the cover back on the air filter assembly is important because it’ll prevent any back-fire, that may occur, from spouting flames out of the throttle body.