How to reset the SRS light on a Honda Odyssey?
I had to search numerous posts before figuring out everything needed to reset the SRS light on my 2002 Odyssey. I thought it might be helpful to someone else to summarize all that I found in one post… 1. Locate the yellow 2-pin MES Connector on the fuse block above the driver’s kickpanel (two blue wires).
How long does the SRS warning light stay on?
While your car will run with this light on, it is important that you diagnose this problem as soon as possible. Under normal operations, when you first turn the ignition and start the car the light stays on for about 5 seconds and then turns off.
How do you turn off the SRS light?
Turn Ignition off; connect the scs tool (jumper wire, paper clip, etc.) 3. Turn ign on (crank up engine) and wait for SRS light to go off. 4. Disconnect the tool (jumper wire, paper clip, etc.) within 4 sec 5. When the light comes on again, reconnect the tool within 4 sec. 6.
Where are the fuses on a Honda Odyssey?
1. Locate the yellow 2-pin MES Connector on the fuse block above the driver’s kickpanel (two blue wires). Pull connector out using a small screwdriver to push the release tab. The yellow connector is next to the fuses on the fuse panel itself (driver’s side kick panel).
Why is my Honda Odyssey SRS light not working?
A weak battery allows electrical noise in the system which seems to show up first as an internal SRS unit failure. Have them reset it and if it isn’t a solid failure replace the battery. The procedures in the Honda service manual are different for the 99-02 and 03-04.
What happens when the SRS light goes off?
The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal.
What does the SRS light on a Honda do?
The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.
What does SRS stand for in Honda Odyssey?
SRS was the actual key word as an example I was giving the Admin to troubleshoot this issue a couple of months ago. The results are different with both searches. With the google search giving back all the results and the vB search only returning a few threads.
What kind of damage does a Honda Odyssey have?
F2-11 Rt front airbag and rt front seat belt tensioner deployed. (This may have been from the accident the vehicle was in before I bought it. It suffered rt front end damage when it slid into a guard rail. Howeve, the air bag did not deploy (not sure if there was a passenger along or not). 53-33 Internal Failure of SRS Unit.
Where is the fuse block on a 2002 Honda Odyssey?
On my 2002 Ody EX-L, the connector appears to be ‘plugged into’ the fuse block. Once you release it, you’ll notice there are no pins in the ‘socket’, so its not really a socket, but stowage for the connector.
Can you reset the SRS light on a Honda Odyssey?
Did you reset the light on your 03 Odyssey using the method that is show a lot on this site (Jumper wire, MES connector), because in the manual it lists for 03-04 odysseys the only way to clear the SRS light is to use the HDS system. It shows you can only use the jumper method with 99-02 odysseys.
F2-11 Rt front airbag and rt front seat belt tensioner deployed. (This may have been from the accident the vehicle was in before I bought it. It suffered rt front end damage when it slid into a guard rail. Howeve, the air bag did not deploy (not sure if there was a passenger along or not). 53-33 Internal Failure of SRS Unit.
On my 2002 Ody EX-L, the connector appears to be ‘plugged into’ the fuse block. Once you release it, you’ll notice there are no pins in the ‘socket’, so its not really a socket, but stowage for the connector.
Why does my SRS light keep coming on?
If the light comes on otherwise, then there is a problem with the internal diagnostic system. No worries as this can be remedied with an effective at-home fix which can, in turn, save you a lot of money. Continue below to learn how to Reset the SRS Warning Light.
What does the SRS light mean on a Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit. The only way to check this is with a scan tool of some sort. I used a Solus Pro.
What does it mean when SRS light is on?
The SRS light referes to the supplemental restraint system. This involves your airbags. The light indicates that the system has a problem and is disabled. We need to get the vehicle in to do some testing to isolate the problem and figure corrective measures.
What happens when you turn off the SRS light?
The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire. The SRS light will turn off. Disconnect the shorting wire.
Is it normal for Honda SRS light to come on?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it.
Is there a way to reset the SRS light?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.