What is maintenance light?
However, a Maintenance Required light is a light that comes on after a set amount of miles. It’s there to remind you every so often to check and change things like your oil and such. It can usually be reset, which will turn it off until the car has recorded that set amount of miles again.
What does the dash light mean ” maintenance required “?
It’s there to remind you every so often to check and change things like your oil and such. It can usually be reset, which will turn it off until the car has recorded that set amount of miles again. There should be a button in your car to reset it, although it might not be in plain sight.
What does the service required light on your car mean?
These warning lights are unrelated. The service required light just means the car is due for an oil change or other routine care. It is not an indicator of trouble like the check engine light is.
How to reset the maintenance required display reset?
Step one: turn key. Step two: start atv. Step three : look away and enjoy the scenery of your surroundings. Step four: look back at cluster msg gone. Here is a How-To for manually resetting the “Maintenance Required” code that comes up each time your CanAm is due for maintenance per whats programmed from the factory.
What does the “maintenance required” light mean?
The maintenance required light (maint reqd) indicates that factory service interval has been met. These intervals happen at different mileage or time intervals (typically 5000 miles/6 months).
How do you reset the maintenance required light?
Turn of Maintenance Required Light. Here’s what to do: With the car off and key out, hold in the odometer select/reset button. Insert the key and turn to the run position without starting the car. Keep holding the button in. The Maintenance Required Light will blink once and then in another 5-10 seconds.
How do I reset the required maintance light?
- Turn ignition switch to the ON position
- Trip Display to TRIP A mode
- Turn the ignition switch to the OFF position
- Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.
How do I reset maintenance light?
Turn your vehicle’s ignition to the “acc” setting while holding the button. Do not crank the vehicle. Hold the position for five seconds and turn the ignition key off. Release the button. The maintenance light will be reset and will illuminate again the next time service is due.