Why are my power sliding doors not working?
Some people on the Internet say that the problem went away after they had the dealer flash the BCM (Body Control Module). Other people had to get an entirely new BCM before the problem disappeared.
What to do if power sliding doors on Dodge Caravan stop working?
Some people on the Internet say that the problem went away after they had the dealer flash the BCM (Body Control Module). Other people had to get an entirely new BCM before the problem disappeared. We never went down either of those paths since I had a simple quick, although temporary, fix.
What to do if your Nissan power window is not working?
Nissan has issued a service bulletin to address Nissan power window problems where the power windows may not work properly after the vehicle’s battery has been disconnected or a window fuse blows. Do NOT replace the window regulator or window controller. The Nissan power window problems can be corrected by performing a re-initialization process.
Why does my car lose the automatic window control?
However, many modern cars will lose the automatic window function after battery replacement. This means that the power window will still go up and down but the one-touch automatic function is lost. This happens because parameters stored in the window control module get lost during battery replacement.
Why does my drivers side window not work?
A smaller version of GM’s rebirth of the Hummer. Hard to start yesterday,drivers side window,power door locks wont work,either by buttons on both doors or on key fob.Other windows work! Replaced Battery checked door lock fuse,still no drivers side window or door locks. Answered! View the answer I have this problem too Is this a good question?
Why does my driver side door lock not work?
The windows and the locks are on two separate circuits. The only part that these two have in common is the master switch. Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact.
What to do if power sliding door does not work?
To fix the problem, seal the power sliding door rear pulley mount, reposition the foam block, dry connector C701, and apply dielectric grease to the connector. You’ll need Lithium Dielectric Grease: and 3M Super Silicone Sealer: Remove the two screws holding the power sliding door control unit. Move the sliding door control unit out of the way
Where is the button on the side of the sliding door?
Note: At some point you will either want to disconnect the positive battery terminal from your battery or simply put the sliding doors in manual mode so you can manually open and close your sliding door as needed to complete the repair. The button to put the sliding doors in manual mode is located at the left knee of the driver: