How do you charge a remote control helicopter?
Charge via Remote Control: Open the charging lead compartment on the underside of the lower left hand corner of the remote control, and extend the charging lead. Turn the remote control ON. Plug the other end into the charging socket on the side of the helicopter.
Why is my RC helicopter spinning?
A gyroscopic controller is used to coordinate the main and tail rotors so the helicopter can fly straight. When this system is not working correctly the helicopter will spin in circles. If the tail rotor blades are not pitched correctly they will not be able to hold the helicopter still.
What causes a helicopter to spin out of control?
A helicopter may spin out of control when the anti-torque system is unable to counteract the torque being created by the engine. When the torque of the engine is greater than the thrust being produced by the anti-torque system, the helicopter will begin to spin.
How do you charge an exceed helicopter?
How to Charge: please connect the helicopter to the computer or tablet by cable to charge. It doesn’t indicate any light while charging but indicates red light once fully charged. Flying Instructions: 1.
What kind of technology does Blade Helis helicopter use?
Blade Helis employ Spektrum AS3X Technology to provide a responsive, predictable and stable flight, right out of the box. Our team of engineers, testers and team pilots spend hours tuning the AS3X built into the flight controller so you get a expertly setup aircraft with no additional settings required.
Where are the cogs on a Bladez helicopter?
There are 2 small cogs on 2 short spindles inside the mechanism that drive large cogs that in turn drive the top and bottom blades. The bottom blades are driven by the top large cog inside the metal housing, which in turn is driven by a small cog on the short spindle next to the “pilot’s cab”.
What should I do if my helicopter spins?
If your helicopter is rotating there are a few adjustments that you will need to make. Your transmitter should have a knob on the top labeled left & right, this knob is used to adjust the wavelengths. If it is rotating anticlockwise (right) then you need to adjust the knob to the left.
How does a single rotor helicopter counter rotate?
On single rotor craft, the counter rotation is most often controlled by the small vertical blades on the back. I know nothing about a “Bladez” but it sounds like what is supposed to counteract the torque isn’t working.