Why does my car keep say tighten fuel cap?
If the fuel fill cap is missing or not tightened properly, you will see ”TIGHTEN FUEL CAP.
How to reset the warning light gas cap that is loose?
Open the door. Grasp the gas cap handle and twist it counterclockwise to unscrew it. Remove it. Replace the gas cap. Removing and replacing it ensures the thread seals properly, in case it wasn’t before. Turn the gas cap clockwise to tighten it. Continue turning until you hear it click three times. This ensures it’s seating properly.
Why does the gas cap light come on but not the Check Engine light?
If there is any abnormal wear or damage to it, even a new gas cap may not seal properly. It can also be possible that there is an EVAP system leak or fault even though the check engine light is not on or an EVAP system leak fault present.
What does the Check Engine light mean on a Honda?
The check engine light is a light that the engine computer uses to signify that there is something wrong. They are orange, amber, or yellow, and not to be ignored! The only way to “reset” the check engine light is by fixing the problem causing it. Thus, the 10 reasons I list below may help you reset your check engine light.
What does it mean if your gas cap is loose?
This system monitors a number of engine and emissions-related components to ensure that everything is in working order. If your gas cap is not properly attached, you may see a “Check Engine” light or a “Loose Cap” warning light on the dash.
How to fix Honda Pilot emissions warning light?
Re: Honda pilot emissions warning light. To resolve the issue, tighten the gas cap or replace it, and then disconnect the battery. Let it sit for 5 to 10 minutes and then reconnect it. If not solved, then there can be a variety of reasons why these lights illuminate i.e. the fuel injector may need to be replaced.
When to tighten fuel cap on Honda Pilot?
We cleared the codes and it lasted for about 5 days, then the Tighten Fuel Cap message came back on the message board, but no engine codes. After a week or so it turned into an engine code like before with the Check Emissions System message. 4.
Open the door. Grasp the gas cap handle and twist it counterclockwise to unscrew it. Remove it. Replace the gas cap. Removing and replacing it ensures the thread seals properly, in case it wasn’t before. Turn the gas cap clockwise to tighten it. Continue turning until you hear it click three times. This ensures it’s seating properly.
How can I Fix my Honda Pilot engine?
Bring the Honda to a parts store to have them read stored engine codes to determine what’s going on (a free service at most stores). They will plug a hand held scan tool into a diagnostic port under the dash, and ‘read’ any codes in the cars computer.