What rear end do I have in my Chevy truck?

What rear end do I have in my Chevy truck?

You can typically find your RPO code on driver side door panel or glove box. General Motors rear end differentials are referred to by the diameter of the ring gear, i.e. 7.5 inch, 8.5 inch, 10.5 inch.

How do I identify my Chevy rear differential?

The rear cover’s shape and the number of bolts are identifying features for GM rear differentials. The round 10-bolt cover with a bulge for the ring gear identifies this axle assembly as an 8.5-inch 10-bolt. The two lugs on the lower case at the 5 and 7 o’clock positions are also identifying features.

What is a Dana 60 rear end?

The Dana 60 is a Salisbury-type rear-end, meaning the differential carrier removes from the rear of the axle instead of the front. It can be identified by its 10-bolt rear cover, which appears to be lying on its side.

Is a Chevy C10 a half ton?

The most common pickup was the C10, a half-ton truck with a 6.5- or 8-foot cargo box. The C/K series trucks remained essentially the same vehicle during a series of conservative redesigns, until 1997, when the 1998 Silverado replaced it.

How big is the rear end of a Chevy?

After that, GM instituted the “Corporate” rear end, a 10-bolt rear end that integrated feartures of both the 10- and 12-bolt rear ends. Rear ends with measurement designations are named after the diameter of the ring gear, i.e. 7.2 and 8.5 inch.

Can a Chevy 1 ton axle be rebuilt?

Like any automotive component, they will eventually wear out and require a rebuild or replacement. Houston Rebuilt Axles can rebuild your chevy 1-ton axles to make it as good as new. We use OEM standard replacement parts and every rebuilt axle comes with our warranty so you can have piece of mind that your freshly rebuilt axle will last.

What was the wheelbase of a Chevy truck in 1965?

In an effort to increase front-axle load, Chevy extended the wheelbase for 1965 to 115 inches and added five inches to the dimension between the back of the cab and the rear axle. The distinctive grille was highly polished, anodized aluminum.

What makes up the rear end of a car?

A rear end of a car is the combination of the rear axle and differential gears located at the rear of the vehicle encased in either a cast-iron or aluminum housing.