Where is the OBD port on a 2017 Honda Accord?
The port can be located on the drivers side of the cabin to the left of the steering wheel. It’s under the dash panel that sits above the brake pedal next to a box that houses the Accord’s fuses. EOBD codes are specific to Europe and European vehicles.
Where is the OBD connector on a Honda Accord?
OBD connector location for Honda Accord (1997 – 2002) You will find below several pictures which will help you find your OBD connector in your car. OBD Connector is located on the central console (passager side) Go to the OBD2.
What kind of connection does Honda diagnostic DLC have?
The good old Manual I have refers to the O/W cable of the DLC as a K-Line. I also read a few very good posts for the Suzuki/busa where there ECU’s have a similar 10400 baud half duplex connection. They have done wonders with this connection from datalogging (what I’m after) to mapping.
Is there a K line for a Honda DLC?
0 Members and 2 Guests are viewing this topic. Sorry if but can’t find much about this or any Honda site. I have a 2007 biffer. The good old Manual I have refers to the O/W cable of the DLC as a K-Line. I also read a few very good posts for the Suzuki/busa where there ECU’s have a similar 10400 baud half duplex connection.
What kind of wire does a Honda DLC use?
The DLC wires that are jumped by the tool vary in color from model to model- the CBR250R uses blue and green wires, but the VFR1200F uses brown and green wires. Make sure to have the service manual to correctly identify the wires of the DLC if attempting a jump of the DLC without the tool. Locate the red 4-pin DLC to use the SCS service connector.
Where is the OBD plug on a Honda Accord?
You will find below several pictures which will help you find your OBD connector in your car. The OBD2 socket is located under the steering wheel in the fuses box OBD socket is near the hood lever You can see the diagnostics port near the fuses
How do you short the DLC terminals on a Honda?
Turn the ignition switch ON and the engine stop switch to RUN. Remove the special tool to disconnect the jump. The MIL will light for approximately 5 seconds. While the MIL lights, short the DLC terminals again with a special tool. The self-diagnostic memory is erased if the MIL goes off and then starts blinking.
What is the short service connector on a Honda?
The tool, part number 070PZ-ZY30100, is an electrical connector with a built in jumper wire. The tool connects to the Data Link Connector (DLC), and jumps two wires of the DLC to create an input to the ECM. While the wires can be jumped manually without the tool, the tool insures the correct wires are jumped.