Where is the plug for the Horizon Elliptical?
power cord
Plug in the power cord to power the elliptical ON. (Switch is located at the bottom-front of the elliptical.)
How do I reset my horizon elliptical?
Reset the console by pressing the STOP and SPEED “+” or “^” for five seconds.
How do I turn on my horizon elliptical?
A Open HARDWARE BAG 4. (L) and another FLAT WASHER (N) onto the CONSOLE MAST. MAST and attach using 1 FLAT WASHER (N), 1 FLAT WASHER (K), 1 HANDLEBAR CAP, 1 SPRING WASHER (B) and 1 BOLT (M). elliptical.
Do ellipticals plug in?
In short, yes, you have to plug it in to really use it properly.
Why is my treadmill not starting?
If the treadmill won’t start with the safety key inserted, unplug the treadmill and check the wire harness connections between the console display and the motor control board. Reconnect any loose wires and repair any broken wires. If you hear the drive motor buzz but it doesn’t run, replace the drive motor.
Are ellipticals Easy to assemble?
This machine is not overly difficult to assemble nor disassemble. There two small wheels at the front of the machine that can be used to roll it out of the way when you’re not using it. This reasonably priced elliptical is a versatile and fun piece of equipment.
Is it hard to set up an elliptical?
If you aren’t mechanically inclined, putting an elliptical together can be a challenge, both physically and mentally. While most elliptical trainer installation can be an easy do-it-yourself job, if you want to have your new machine properly installed and calibrated, let a pro set it up for you.
Should I unplug my elliptical when not in use?
Power strips can also result in error messages being sent to the treadmill electronic board when there’s nothing actually wrong with the machine. The best rule of thumb is to avoid using a power surge protector and instead unplug the power cord from the wall outlet after each use.