What kind of transmission does a 1997 GMC Jimmy have?

What kind of transmission does a 1997 GMC Jimmy have?

Mine is a 1997 Jimmy 4×4. When it is cold outside, the transmission shift hard from 1-2 and takes quite awhile (as well as a low speed) to shift from 2-3-4. The RPM needle shakes violently back and forth thus preventing the vehicle to obtain speed. The vehicle WILL shift eventually, but this make going up a slight hill very slow and time consuming.

Why does my GMC Jimmy not go into gear?

MY JIMMY WILL GO INTO GEAR WHEN I FIRST START IT UP, BUT WHEN IT WARMS UP I GOT NOTHING. SO COULD IT BE THE TRANSFER CASE OR THE TRANS. ANY HELP WOULD BE THANKFUL.

How do you check the transmission fluid in a GMC Jimmy?

Transmission fluid should always be checked at operating temperature to ensure an accurate measurement. Keep the engine running. Place your foot on the brake pedal. Move the shift lever through the different gears, pausing for three seconds with each gear before continuing to the next gear. Finish with the shift lever in Park (P).

Where is the transmission dipstick on a GMC Jimmy?

Locate the transmission dipstick, which is under the TRANS/LOCK handle near the center of the engine compartment. Flip the handle up and pull the dipstick out. Wipe the tip off with a clean rag. Replace the dipstick and push it all the way back into the reservoir. Wait three seconds and remove the dipstick.

Mine is a 1997 Jimmy 4×4. When it is cold outside, the transmission shift hard from 1-2 and takes quite awhile (as well as a low speed) to shift from 2-3-4. The RPM needle shakes violently back and forth thus preventing the vehicle to obtain speed. The vehicle WILL shift eventually, but this make going up a slight hill very slow and time consuming.

Why is my GMC Jimmy transmission so slow?

When it is cold outside, the transmission shift hard from 1-2 and takes quite awhile (as well as a low speed) to shift from 2-3-4. The RPM needle shakes violently back and forth thus preventing the vehicle to obtain speed. The vehicle WILL shift eventually, but this make going up a slight hill very slow and time consuming.

Why does my GMC Jimmy start in 3rd gear?

I have a 97 4wd Jimmy. This started about almost a month ago. It was at first an every once and a while thing at the start but it seems as if it is pretty constant now. When the car is place in the Over Drive position, it does not seem to start in the 1st gear position. Possibly 3rd gear is where it starts.

Is the GMC Jimmy a four wheel drive car?

The four-door GMC S-15 Jimmy was offered in both four-wheel drive and two-wheel drive variants. For the 1992 model year, the “S-15” label was removed from the GMC Jimmy.

When it is cold outside, the transmission shift hard from 1-2 and takes quite awhile (as well as a low speed) to shift from 2-3-4. The RPM needle shakes violently back and forth thus preventing the vehicle to obtain speed. The vehicle WILL shift eventually, but this make going up a slight hill very slow and time consuming.

How much fluid does a GM 4L60E need?

The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.

What kind of transmission does a 1994 GMC Sierra have?

I’ve got a 1994 GMC Sierra 4X4 5.7 I purchased from an older couple. It has been sitting a year. She said years ago they had tranny trouble; it would stay in low.

The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.

What kind of transmission is the 4L60E?

What is a 4L60E Transmission? The 4L60-E is an automatic shift, four-speed overdrive, longitudinally positioned transmission. It has been considered to be the best rendition of the finest overdrive automatic transmission ever produced.

What was the name of the GMC Jimmy truck?

The big Jimmy was soon renamed as the Yukon in 1992 and up to know is still a big seller. The smaller S-15 Jimmy used the compact Chevrolet S-10 truck chassis. It was produced from 1983 through the early 2000s, when the GMC Envoy effectively replaced the Jimmy.

When did the GMC Jimmy V6 come out?

After 1985, the Jimmy replaced the Isuzu engine and the other diesel engines with a 2.5-liter engine. When 1986 came, the V6 engine received a throttle-body fuel injection. The first four-door GMC S-15 model became available in 1990. This version received a wheelbase that is 6.5 inches longer than the original S-15.

When did the GMC Jimmy Trailblazer come out?

Upon introduction of the 2002 Chevrolet TrailBlazer and the GMC Envoy, production continued after their successors came to the market, with the Jimmy being sold only in Canada and, in the 2005 model year, 4-door models sold to vehicle fleets. Another upscale model was the 1998 GMC Envoy.

What does it mean when transmission runs only in 2nd gear?

Transmission runs only in 2nd gear. This is known as running in LIMP IN MODE. The most important thing to remember, when trying to decide if you have a solenoid issue or internal transmission damage (causing the transmission to stay in Limp-In mode) is two very important things:

Why does my 4L60E have no reverse?

Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.

What was the name of the first GMC Jimmy?

With its robust body and stylish design, the GMC Jimmy produced two generations of first-rate SUVs. The first batch of GMC Jimmy models was initially called the GMC S-15 Jimmy. The original S-15 was specifically smaller than the full-size K5 Blazer, but they were both available only with a two-door body style.

Why is the ABS light not working on my GMC Jimmy?

The ABS light stays on,the engine light stay on, the speedo doesn’t work, and it doesn’t shift into 3rd, only 1st and 2nd. At first it would only stay in 1st, i topped up to oil and then it went into 2nd.