What is P2135 code?
The OBD-II scanner error code P2135 problem refers to a problem with the voltage transmission between the throttle and its sensors. While the issue might be due to a faulty Powertrain Control Module, it is likely best to take your vehicle in for diagnostics.
What does the p2135 code on the throttle mean?
The throttle position sensor is located on the throttle body and once it fails, code P2135 may get triggered. What Does the P2135 Code Mean? Diagnostic trouble code (DTC) P2135 stands for “Throttle/Pedal Position Sensor/ Switch A/B Voltage Correlation.”
When to set the TAC code p2135?
A typical TAC system has two TP sensors and two APP sensors for fail-safe reasons. If the data between one of the sensor pairs (e.g, the two throttle position sensors) does not correlate, code P2135 is set. In most cases, the ECM will also force the vehicle into Reduced Power Mode.
Why is my PCM setting the code p2135?
If one throttle position sensor is reading at half throttle and the other is reading at full throttle, the PCM will set a code P2135 because the voltage readings will be so remote that it is impossible for the data to be accurate. The throttle position sensors will be located on the throttle body inlet.
What is the diagnostic code for throttle / pedal position sensor?
P2135 is a diagnostic trouble code (DTC) for “Throttle/Pedal Position Sensor/Switch A / B Voltage Correlation”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
The throttle position sensor is located on the throttle body and once it fails, code P2135 may get triggered. What Does the P2135 Code Mean? Diagnostic trouble code (DTC) P2135 stands for “Throttle/Pedal Position Sensor/ Switch A/B Voltage Correlation.”
What to do if your computer error code is p2135?
There are a few repairs that can be done to resolve the error code. First, you can replace the accelerator position sensor. Then, you can see if installing new throttle position sensors fixes the error. If neither of these solutions works, then you can try checking for a fault in the circuits or connections.
What to look for in Nissan p2135 code?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P2135 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
When does DTC p2135 set in the PCM?
The two TPS sensors operate inversely — one has an increasing voltage when throttle is applied and one has decreasing voltage on throttle application. If the two TPS sensor readings don’t correlate in the PCM for more than a couple seconds, DTC P2135 is set in the PCM. What are the common causes of code P2135? What are the symptoms of code P2135?