Why does my Troy-Bilt pressure washer not start?
Common solutions for: Troy-Bilt Pressure washer won’t start If the porcelain insulator is cracked, an electrode is burned away or damaged, or there is heavy carbon buildup at the electrode, replace the spark plug. To determine if the spark plug is defective, use a spark plug tester.
What do you do when your pressure washer won’t start?
If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor. The ignition coil sends voltage to the spark plug while the engine is running. If the ignition coil is defective, the engine may not start.
How do you troubleshoot a Troy-Bilt pressure washer?
How to Troubleshoot the Troy-Bilt Pressure Washer
- Replace the low-pressure spray tip with a high-pressure spray tip.
- Check the water inlet for blockages and clear the inlet if you discover blockages.
- Check the inlet hose and verify that the unit is receiving adequate water flow.
- Check and clean the inlet hose screen.
How do you start a pressure washer that has been sitting?
Start by connecting your garden hose to the pressure washer and turning on the water. Connect your high-pressure hose and wand. Pull the trigger on the wand to allow trapped air to escape. With the water running, hold the wand’s trigger open with one hand (pointed in a safe direction) while you start the engine.
How do you troubleshoot a Troy Bilt pressure washer?
Why is my pressure washer locked up?
If you tipped the pressure washer on its side recently, oil may have filled the cylinder, preventing the engine from spinning. If the recoil starter spins after removing it from the engine, then the engine is locked up. You’ll likely need to have a service technician examine and repair the locked-up engine.
Is it OK to start a pressure washer without water?
Although you can start a pressure washer without water, it is not advisable to do it. The water helps to lubricate the pump and help to keep it cool. Without the lubrication and cooling properties of the water, dry starting will cause the pump to wear down quickly.
What should I do if my Troy Bilt pressure washer wont start?
So if your Troy-Bilt pressure washer engine shows no signs of life, empty the tank and flush the fuel line clean of any old fuel traces. Spray some advised carburetor cleaner into the carburetor to eliminate the oil clogging the insides. Refill the tank with fresh fuel and then attempt to start the engine again.
What to do if your pressure washer won’t start?
If the fuel is right to go and your pressure washer still won’t start, there are a few other possibilities. Before you throw in the towel, give these items a quick once-over first: Check the air filter. If it’s dirty or damaged, replace it.
What happens if you use old gas on pressure washer?
If a decent amount of time has passed since you last used your pressure washer, then the odds are excellent that the fuel has gone bad. Old gas is not your friend; it can get gunky and carry a number of contaminants that can damage the engine. Refrain from using gas longer than 30 days old, even if you have regularly used your washer.
Can a pressure washer be run without water?
Never run the pump without the water supply connected and turned on. This will cause damage to the equipment. Such damage may void your pressure washer’s warranty. Turn the water source on. Point spray gun in a safe direction and squeeze the trigger to eliminate the pump system of air and impurities.