Is there a problem with my Honda Accord rear brake?
Premature rear brake wear is a common problem on 2008-2010 Honda Accords. There are over 1,000 reports of premature brake wear for the 2008 Accord alone on carcomplaints.com. Keep in mind that only includes people who took the time to note their complaint
How do you replace a brake caliper on a Honda Accord?
Put the round pin into the top of the caliper. Replace your worn brake pads with new ones. Reinstall the caliper onto its bracket. Reinstall the wheel onto the hub. Lower the wheel to the ground. Tighten the lug nuts to 80 foot-pounds. Repeat on the other rear wheel.
What does EBD do on a Honda Accord?
For 2008 Accords, Honda introduced a new braking system called the Electronic Brake Distribution system or EBD. EBD pushes the rear brakes harder than other braking syste ms to prevent nose dive. Consequently, the early EBD systems were found to have a design flaw that caused them to wear out brake pads too quickly.
How often do rear brake pads wear out?
On Honda owner forums, some have even noted pads wearing out in as little as 10,000 miles. That means some Accord drivers found themselves changing their rear brake pads every year or two. What makes the pads wear so fast?
Premature rear brake wear is a common problem on 2008-2010 Honda Accords. There are over 1,000 reports of premature brake wear for the 2008 Accord alone on carcomplaints.com. Keep in mind that only includes people who took the time to note their complaint
What are the problems with a 2007 Honda Accord?
Worst 2007 Honda Accord Problems #1: Premature Warped Rotors And Brake Wear 2007 Accord Average Cost to Fix: $200 #2: Chipping Paint And Rust 2007 Accord Average Cost to Fix: $800 #3: A/C Condenser Prone To Damage By Road Debris 2007 Accord Average Cost to Fix: $900
For 2008 Accords, Honda introduced a new braking system called the Electronic Brake Distribution system or EBD. EBD pushes the rear brakes harder than other braking syste ms to prevent nose dive. Consequently, the early EBD systems were found to have a design flaw that caused them to wear out brake pads too quickly.
Put the round pin into the top of the caliper. Replace your worn brake pads with new ones. Reinstall the caliper onto its bracket. Reinstall the wheel onto the hub. Lower the wheel to the ground. Tighten the lug nuts to 80 foot-pounds. Repeat on the other rear wheel.
Why does my car make a noise when I change the brake pads?
When the brake pads are worn down and need replacing, this metal tab starts to drag along the rotor, warning the driver of the potential problem. Don’t ignore the noise too long; the brake pads are thin and need servicing very soon, for safety and to protect the other parts of the braking system.
Why does my Honda Accord have idle air control code?
While the code specifically mentions the “Idle Air Control System”, it would be a mistake to just go ahead and replace it without a little due diligence. The Idle Air Control Valve is often not the cause of the code. Here are some of the most common causes of P0507 in the Honda Accord, as well as waist to troubleshoot them.
What causes Honda Accord p0507 to idle higher?
Honda Accord P0507 Causes and Diagnosis 1 Vacuum Leak. A leaking vacuum system will often cause the Accord to idle higher. 2 Idle Air Control Valve. Most modern fuel injected engines are equipped with an idle air control valve. 3 Throttle Body. A throttle body opens and closes millions of times in the life of a vehicle.
When did the Honda Accord brake caliper need to be replaced?
Rear tires overheated to the point that it would burn a hand that touched it on 6-11-2012 (mileage 46,384). Smelled of burning rubber. Had to replace the left rear brake caliper, brake pad, and rotor. On 4-18-2013 (mileage 65,922) the same problem on right rear. This required replacement of the right rear brake pad and rotor.
Where is the emergency brake light on a Honda Accord?
It is under the dashboard on the driver’s side. Press down on the button on top of the brake light switch, giving you enough clearance to insert the brake light switch stopper. Insert the brake light switch stopper. Release brake pedal (remove the wedge if you used one). Your emergency brake lights should now be off.
Why does my Honda Accord shake when I brake?
There were two brake problems reported on the Car Complaints website by means of the NHTSA. One owner complained that the brake pedal didn’t respond as quickly as it should. Braking with this car was more difficult than they had anticipated. The harder they braked, the more the car would shake until it came to a complete stop.
Rear tires overheated to the point that it would burn a hand that touched it on 6-11-2012 (mileage 46,384). Smelled of burning rubber. Had to replace the left rear brake caliper, brake pad, and rotor. On 4-18-2013 (mileage 65,922) the same problem on right rear. This required replacement of the right rear brake pad and rotor.
Are there any problems with the Honda Accord?
Since its 1976 introduction, the Honda Accord has become known as a reliable and comfortable daily driver for many. In fact, Car and Driver put the Accord on its 10 Best Cars list 30 times, including the 2008 model. Even the best cars can have problems though, and some 2008 Honda Accords experience unusual brake issues.
Why does my Honda Accord make a whine when I stop?
If you hear squeaks and whines from the back end of your car, whether you’re driving or stopping, have a look at the rear brakes. If there is a problem with the caliper pin, it can also cause brake noise. Honda Accord caliper sets and sub-assemblies are found here. 3. Warped Rotors A vibration when stopping can signal a rotor problem.
How do you repair a Honda Accord brake bleeder?
2. Attach a length of clear drain tube to the bleed screw. 3. Have someone slowly pump the brake pedal several times, then apply steady pressure. 4. Starting at the left-front, loosen the brake bleeder screw and bleed out any air. Move the the right-front next followed by the right rear and left rear.
How do you turn off the brake lights on a Honda Accord?
Use a flat head screwdriver to push against the switch. Then with the circular, flat end of the pedal stopper pad facing the switch, snap it into place. Release the brake light switch.
How do you replace the drum on a Honda Accord?
Thread two bolts–size 8 x 1.25 millimeters–into the brake drum’s threaded holes to remove the drum from the hub. Thread each bolt two turns at a time. Insert a small, thin piece of wood, like a paint stick or ruler, in between the wheel cylinder and the rear brake shoe.
When do the brakes wear out on a Honda Accord?
There are over 1,000 reports of premature brake wear for the 2008 Accord alone on carcomplaints.com. Keep in mind that only includes people who took the time to note their complaint What Causes the Accord Brakes to Wear Out So Fast? On Accord models, the rear brakes pads can wear out between 15,000-20,000 miles.