What kind of bolts have two raised dashes?
If you purchase a corrosion resistant (stainless steel) bolt, the head of that bolt should have one raised dash. An aluminum bolt will have two raised dashes on its head. Aluminum bolts have limited use.
Where can I find the correct dash number for a bolt?
Each dash number specifies a different length for different bolt diameters. You must refer to a size chart or AN bolt gauge to find the correct dash number. The bolt grip length charts linked below are especially handy when replacing non-AN bolts.
Can a dash be removed from a car?
the dash should swing down now far enough to access the heater core. Also, if the dash needs to be completely removed, it’s as easy as unscrewing the two grounds from the frame, and a couple of switches near the glove box, and carefully snaking out the harness. Last edited by v8only; 08-05-2009 at 01:03 AM . Great pics and instuctions!
Do you have to replace cylinder head bolts?
Warning: Most head bolts are torque-to-yield. These head bolts are single use only and once removed must be replaced. Torque-to-yield head bolts stretch when they are torqued to allow them to tighten properly and repeated application can cause the head bolt to break.
Each dash number specifies a different length for different bolt diameters. You must refer to a size chart or AN bolt gauge to find the correct dash number. The bolt grip length charts linked below are especially handy when replacing non-AN bolts.
How to remove the dash from a car?
1. the first step is to remove the inst cluster cover. I have circled the areas where the philips screw will need to be removed. After these screws are out, simply pull the cover towards you, and lift up and it’ll come straight out. 2. The next step is to remove the dash pad. This shot is from the bottom.
How long will it take to break Usain Bolt’s 100 meter dash time?
According to Sumpter, it should take another 20 years. Amaral’s answer: it could take up to 230 years. Figure A: Trial times for Bolt below 9.93 seconds. The blue line is the truncated Bell curve that best fits the data. In order to answer the first question, Amaral reviewed Bolt’s times for the 100-meter dash.
How do you remove a dash harness step by step?
Reach behind and feel the tab on the speedo cable (I have it circled below). Pushing on this tab will allow you to release and pull the speedo cable out. After that, the inst cluster will pull out a little more where it will show you the two main harnesses you must remove next.