Why is my Worcester boiler not igniting?
If the boiler is not igniting, there is a possibility the valve is blocked, seized or there is damage in the wired connections. No Pilot Light: When the boiler is not igniting and the pilot light has gone out, this usually means debris has blocked the jet.
How do I reset my Worcester 28i boiler?
The appliance can be reset by pressing the fault indicator button and holding in for 5 seconds when the appliance has cooled. If this condition continues to occur, then call a service engineer. The appliance will enter a lockout condition in the event of the burner failing to ignite.
Why will my boiler not ignite?
Some boilers won’t ignite if the gas or water pressure is too low. Low gas pressure could be a problem with supply in the area and you may need to call out the supplier to check. Alternatively, it may be that the water pressure is too low in a sealed system boiler.
How do I reignite my Worcester boiler?
In most cases, you will simply need to hold the button marked ‘reset’ for three seconds. In some models you may see a reset light at the end of the temperature dial. In this case, just turn the dial down to the reset light, leave it there for three seconds and then turn it back to its original position.
How do you fix the ignition lockout on a boiler?
Modern boilers have a reset button on the display button. Once you’ve resolved the underlying issue, simply press and hold the button to reset the boiler after a lockout. For older boilers (or boilers that don’t have a reset button on the front of the boiler) refer to the manual to determine the reset procedure.
How do I reset my Worcester Bosch pilot light?
In the event of a fault, the blue mains indicator light will flash if there is a fault. To reset the boiler turn the Central heating temperature knob anticlockwise to the “RESET” position and hold for approximately five seconds and then turn the knob back to the original temperature setting.
Do Worcester boilers have a pilot light?
I’m sorry to hear of the problems you are encountering with your Worcester Greenstar condensing boiler. We are a little confused with your comments though as the Greenstar doesn’t have a pilot light, the boiler has a fully automatic ignition system.
Why won’t the pilot light come on?
If your pilot light won’t stay alight, it might be the thermocouple. Sometimes dust buildup collects on the thermocouple and blocks the sensor. Try cleaning the thermocouple and then relighting the pilot light. If it continues to go out, the thermocouple might need to be replaced.