What does error code p1298 mean on Eld?
Error Code P1298 is defined as Electric Load Detector Circuit High Voltage. This means the ELD (Electric Load Detector) is getting high input voltage. This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present.
What does p1298 mean on Honda Charger?
If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit. This code specifically pertains to a condition in which a voltage signal that is higher than anticipated has been perceived.
Which is Honda load detector has high voltage?
P1298 – Electric Load Detector Circuit High Voltage (Honda) Trouble Code Fault Location P1298 Electric Load Detector Circuit High Volt
How to reset the p1298 load detector code?
Connect the scanner to the vehicle diagnostic connector and retrieve stored codes and freeze frame data. Write it down as it will almost always come in handy if the diagnosis drags on due to an intermittent condition. Clear the codes and operate the vehicle under various electrical load conditions to see if the code P1298 is reset.
When did Honda p1298 Eld circuit voltage high trouble code?
On May 6, 2005 Honda issued a service bulletin #05-006 to address the issue a P1298 ELD circuit voltage high trouble code. The service bulletin advises that Honda has discovered a faulty solder joint on the ELD and recommends replacement with an updated part #38255-S5A-003, H/C 7987571.
What to do when your load detector says p1298?
If the code comes back, turn the off both the headlights and the ignition. Disconnect the ELD 3P connector, which is located behind or underneath the under hood fuse box.
Why does my car have an error code p1298?
Usually, there are no other noticeable symptoms. In some cases, however, the engine may suffer rough idle, especially when the vehicle settles down or transitions from high throttle to rest, or the engine feels like it’s misfiring. There are multiple reasons for this code to appear, some of the most common causes include:
What does the p1298 Honda electric load detector do?
P1298 HONDA Meaning. The Electric Load Detector (ELD) measures the main current flow and sends that signal to the Engine Control Module (ECM) to command the alternator charging system to get fuel efficiency and decrease the drag of the engine when starting.
What does the code p1298 mean on a Honda Accord?
What Does Code P1298 Mean? If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit.
Can a Honda Civic have a high voltage Eld?
Alternator failure will rarely result in a high voltage condition at the ELD but follow the guidelines set forth in the vehicle information source and corresponding TSB/s for diagnosing and repairing charging system malfunctions for the specific vehicle in question. 2002 Honda Civic 38k miles and I don’t drive it too hard.
What does an ELD on a Honda do?
Honda vehicles are equipped with an electric load detector (ELD) that measures the load on the charging system and can set a P1298 ELD circuit voltage high when there’s a problem. The ELD sends a signal to the ECM which controls the voltage regulator and adjusts field coil voltage to match the load.
Is there a p2646 code for a Honda Element?
Finally just pulled the oil pan with the upper components taken off, cleaned the oil passages, painted the rusty oil pan with spray on undercoating, put everything back together, been fine ever since, no more P2646 or P2647 codes since, revs well, runs well, Goes like stink from a skunk farm now. My opinion.
What is the fault code for a Honda Accord?
P1297 Electric Load Detector (ELD) Circuit Low Voltage P1298 Electric Load Detector (ELD) Circuit High Voltage P1300 Random Misfire P1324 Knock Sensor Power Source Circuit Low Voltage P1336 Engine Speed (RPM) Fluctuation Sensor Intermittent Interruption P1337 Engine Speed (RPM) Fluctuation Sensor No Signal
What is the error code for Honda Civic?
This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present. Rather, it applies to select vehicle manufacturers, most commonly among Honda vehicles like Honda Accord, Honda Civic, and Honda CR-V.
If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit. This code specifically pertains to a condition in which a voltage signal that is higher than anticipated has been perceived.
Error Code P1298 is defined as Electric Load Detector Circuit High Voltage. This means the ELD (Electric Load Detector) is getting high input voltage. This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present.
Connect the scanner to the vehicle diagnostic connector and retrieve stored codes and freeze frame data. Write it down as it will almost always come in handy if the diagnosis drags on due to an intermittent condition. Clear the codes and operate the vehicle under various electrical load conditions to see if the code P1298 is reset.
When does a PCM get a code p1298?
If the PCM detects a voltage signal from the ELD circuit that is greater than the degree of voltage it expected the alternator to produce at a given time and under a specific set of circumstances, a code P1298 will be stored and a malfunction indicator lamp (MIL) may be illuminated. What are the common causes of code P1298?
P1298 HONDA Meaning. The Electric Load Detector (ELD) measures the main current flow and sends that signal to the Engine Control Module (ECM) to command the alternator charging system to get fuel efficiency and decrease the drag of the engine when starting.
What Does Code P1298 Mean? If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit.
If the PCM detects a voltage signal from the ELD circuit that is greater than the degree of voltage it expected the alternator to produce at a given time and under a specific set of circumstances, a code P1298 will be stored and a malfunction indicator lamp (MIL) may be illuminated. What are the common causes of code P1298?
How much does it cost to fix a p1298 Honda?
What does this mean? The cost of diagnosing the P1298 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
Why do I get an error code on my load detector?
There are multiple reasons for this code to appear, some of the most common causes include: Faulty Electric Load Detector. Faulty PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) Open or shorted Electric Load Detector Harness.
There are multiple reasons for this code to appear, some of the most common causes include: Faulty Electric Load Detector. Faulty PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) Open or shorted Electric Load Detector Harness.