What should I do about my Honda CRV front suspension?

2002-2006 Honda CRV front struts with sway/stabilizer bar links. 2002-2006 Honda CRV control arms and ball joints. Here is a list of the special tools you’ll need for this project. The short video below shows you these tools in action.

Can a ball joint be removed from a Honda CRV?

Because the old ball joint is press-fitted into the steering knuckle under high pressure, you will generally need a ball joint press plus a Honda-specific ball joint removal and installation tool in order to remove and install the ball joint. Some ball joint service tool kits do have adapters that work with Honda ball joints.

Why does my Honda CRV make a clicking noise?

Answer: The noise is from worn out liquefied CV axle grease or worn out CV bearings in the CV inner or out cage. In the absence of high-speed centrifugal force (slow wheel rotation), when a bearing reaches it’s peak, it drops into in CV cage when the cage advances ahead of the bearing. That’s what’s causing the clicking sound.

How do you replace the castle nut on a Honda CRV?

Screw on the new castle nut onto the ball joint shaft. Using a 1/2 socket wrench, torque down the castle nut and align the nut with the cotter pin hole in the ball joint shaft.

How to replace the CV axle on a Honda CRV?

This video will show you how to replace the CV axle on a Honda CRV right passenger side. The right side is a “half shaft” design where another shaft called a “intermediate shaft” protrudes from the transmission till it meets a “carrier bearing bracket”. This shaft only rotates and does not move up, down, left or right like a CV axle.

When was the last time I drove a Honda CRV?

Purchased on 11/07/04 and owned in CA until 06/14/21. Driven an estimated 11,305 miles/year. Last serviced at 187,791 miles in Temecula, CA on 12/07/19 • Vehicle serviced • Cooling system checked. Mileage: 187,825 miles Body Type: SUV Color: Green Engine: 4 Cyl 2.4 L

How many miles does a 2004 Honda CRV Ex get?

Mileage: 175,969 miles Body Type: SUV Color: Gold Engine: 4 Cyl 2.4 L Description: Used 2004 Honda CR-V EX with 4WD, Keyless Entry, Alloy Wheels, 15 Inch Wheels, and Cloth Seats 2004 Honda CR-V EX 19 Photos

How do you remove a CV axle from a car?

Use a punch tool or impact hammer to push the CV axle through the wheel hub. Push down on the lower control arm and pull the axle out of the wheel hub splines. Support the CV axle up and away from the suspension using a bungee cord or strap attached to the CV shaft and the body of the car.

How much does it cost to replace an axle on a Honda CRV?

If you need to replace the front axle in your Honda CRV, it will cost you an average between $260 and $708. Estimated labor costs are between $96 and $123, while parts cost between $164 and $585. For a Honda CRV rear axle replacement, you will have to spend between $565 and $1470.

How does the axle work on a Honda CRV?

Although Honda CRV Axles are remarkably strong parts of your car, it is possible for one or both to shear or fail, requiring needing a new set. Your Honda CRV Axle transfers motive power from the vehicle’s transmission to your wheels to provide forward speed.

What was rear differential filled with in Honda CRV?

Yes the transmission was pulled out to rebuild the front differential. Yes the transmission was pulled out to rebuild the front differential. What was it filled with? What was rear differential filled with? have you tried to get an allignment done? It could also be a broken motor mount…have you replaced the brakes?

How do you change the radiator on a Honda CRV?

Pour in a mix of engine coolant and distilled water (in equal proportion) inside the new radiator. Take the radiator cap off. Switch on the engine for a few minutes, to remove any air out of the system. Switch off the engine and fill the radiator to the brim with the coolant mixture.

How do you remove a transmission from a Honda CRV?

The best way to remove the electrical connectors is NOT to break the tabs on them with a screw driver. Instead, use your meaty hands to squeeze the tab until it clicks, then stick a flatblade screwdriver between the two connectors and twist. Most of the connectors will be pretty seized up.

Where can I get a Honda CRV power door lock replaced?

Howdy Honda dealership here in Austin Texas was able to have front driver side door actuator replaced under warranty. The back driver and passenger doors will NOT lock. The new actuator was going off continuous in attempt to lock the back doors.

Are there any recalls on 2007 Honda CRV?

During this time the clerk said that the 2007 CRV’s has a recall on the drivers side door locks and that he will be changing the door lock. I said okay but nothing is work with my door locks.

What is the header panel on a Honda CRV?

A header panel is a support panel to which other front end body components attach. If a header panel is collision damaged it should be replaced so the front end components can be reinstalled… The CR-V by Honda was unveiled back in 1995, with the first model year being 1997. This compact SUV was derived from the Civic.

What should I replace my Honda CRV with?

Honda CR-V 2007, Door Lock Actuator by Genuine®. If your electrical parts are in need of repair, don’t compromise the performance and safety of your car with suspect, off-brand replacement parts from the local auto parts chain store…. Honda CR-V 2007, Power Window Regulator and Motor Assembly by WAI Global®.

Can you replace the door jamb on a Honda CRV?

Honda CR-V 2007, Door Jamb Switch by Genuine®. If your electrical parts are in need of repair, don’t compromise the performance and safety of your car with suspect, off-brand replacement parts from the local auto parts chain store. On… Honda CR-V 2007, Door Jamb Switch by WVE®.

During this time the clerk said that the 2007 CRV’s has a recall on the drivers side door locks and that he will be changing the door lock. I said okay but nothing is work with my door locks.

What is the actuator on a Honda CRV?

Door lock actuators are the motors that lock the doors to your vehicle upon the control of the door switch. Usually you can hear a broken actuator because it will sound like strange gear… Honda CR-V 2007, Front Driver Side Power Window Regulator and Motor Assembly by SKP®.

When to change the front brake pads on a Honda CRV?

How to change the front disc brake pads on a third generation 2007 to 2011 Honda CR-V with photo illustrated steps. This automotive maintenance tutorial was specifically written to assist owners of the 3rd generation (2007, 2008, 2009, 2010 & 2011) Honda CR-V in changing the front disc brake pads.

Can a Honda CRV front suspension be replaced?

Replacement of the Honda CRV front suspension Strut, Lower Ball Joint and Control Arm and the Sway Bar / Stabilizer Bar link. This constitutes all the components that comprise the front end of the Honda CRV.

How do you take the back seat out of a Honda CRV?

Locate all the retaining bolts holding the CRV’s rear seat to the floor. Tilt the seat forward and remove the retaining bolts with a socket wrench. Pull the seat forward and away from the bolts. Climb out of the CRV and pull the seat out through the open door. Be careful not to scratch the car while you’re pulling the seat out.

What are the features of a 2007 Honda CRV?

Used 2007 Honda CR-V Standard Features. The CR-V is now offered in three trim levels: LX, EX, and EX-L. A tire pressure monitoring system is newly standard across the board, as are 17-inch wheels. The steering column now telescopes as well as tilts.

What are the trim levels of a Honda CRV?

The CR-V is now offered in three trim levels: LX, EX, and EX-L. A tire pressure monitoring system is newly standard across the board, as are 17-inch wheels. The steering column now telescopes as well as tilts. All sound systems have an MP3/auxilliary audio input jack, and speed-sensitive volume control.

Navigation