How do you turn off the check engine light on a 1994 Honda Accord?
Thread: 94 accord EX turn off check engine light
- Put a paper clip, wire, connector in it to connect the two prongs.
- Put the key in the ignition, and turn the key 2 clicks to the acc on, where all the lights light up on the dash.
- You will now watch how many times the CEL light blinks.
Where is the Diagnostic Code on a Honda Accord?
With ignition off, insert jumper wire in service check connector terminals, located behind right side of dash on Accord, Civic and Civic Del Sol and near center console on Prelude. Turn ignition switch to ON position. Diagnostic Trouble Codes (DTCs) will be indicated by a series of long and short flashes on MIL.
Where is the jumper wire on a Honda Accord?
First, check the electrical connections, clean or repair connections if necessary. With ignition off, insert jumper wire in service check connector terminals, located behind right side of dash on Accord, Civic and Civic Del Sol and near center console on Prelude. Turn ignition switch to ON position.
Why is my Honda Accord not starting properly?
Extended idling on hot days can overheat the alternator, lowering its output and the ability of your electrical components to receive power. This is common and should resolve itself as the engine cools. Check for poor connections at the battery or a problem relay if your Honda Accord is sluggish about starting.
Where is the ECU on a Honda Accord?
The ECU is located under the passenger’s seat. Codes are displayed on a series of four LEDs. With the ignition switch in the “on” position and the engine off, codes will be displayed in ascending order. Note: Red * indicates LED on.
Where is the low pressure plug on a Honda Accord?
Locate the AC System and unscrew the low pressure plug. The owner’s manual will direct you to the location of the AC system in your Honda Accord. The low pressure plug, will have the letter L embossed on it, remove that plug and set aside for reinsertion.
What should I do if my Honda Accord AC system is not working?
Clamp the refrigerant canister hose onto the low pressure intake in the AC system. If the clamp does not easily attach to the low-pressure intake, do not force it, double check that you have the OEM A/C system in your Honda Accord, and that the clamp is not damaged.
Where to reset the ECU on a Honda Accord?
If any of these problems are affecting your Civic or Accord, it is very simple to reset the ECU. Keep reading and this how to will guide you through the process. Open the hood and look for the fuse box, which is located near the passenger’s side. The cover contains a diagram of the fuses, which tells you what each fuse is used for and the amperage.
How can I recharge my Honda Accord a / C system?
Turn the canister upside down and right side up while the refrigerant is going into the system. You should feel the canister getting extremely cold. Monitor the pressure gauge on the canister as you are filling the system, and when you get to the optimal psi, remove the hose, and check the vents inside the car for appropriate AC temperature.