Where is the fuel pump and filter located?
9.Remove the fuel filter (B), the fuel gauge sending unit (C), the case (D), the wire harness (E), and the fuel pressure regulator (F). 10.When connecting the fuel tank unit, make sure the connection is secure and the suction filter (G) is firmly connected to the fuel pump (H).
What do you need to know about fuel filter?
This starts with a pre-filter ahead of the pump, along with another filter after the pump with a finer filter and the entire system plumbed with sufficient size lines and full-flow fittings. The return line must also be the same size as the feed line to prevent backpressure.
When to replace the fuel pump and filter?
The fuel filter should be replaced whenever the fuel pressure drops below the specified value (270 – 320 kPa, 2.8 – 3.3 kgf/sq.cm, 40 – 47 psi) , after making sure that the fuel pump and the fuel pressure regulator are OK. Remove the fuel pump. Remove the fuel filter (A).
How is the fuel line attached to the fuel filter?
Fasten the fuel filter to the fuel line. Slide the fuel lines onto the front and back of the filter the same way they were attached to the old one. With the fuel line in place on the filter, slide the plastic clips through the holes on the fuel line nozzle to secure the line in place on the fuel filter.
Where is the fuel filter located in a car?
The most common location for modern vehicles is along the fuel line on the bottom of the car, just past the fuel pump. In some vehicles, the fuel filter is located in the engine bay on the line that leads to the fuel rail.
What kind of fuel filter do I need for an inline pump?
For inline pumps where it is located outside the tank, a 100 micron pre-filter is recommended. This larger filter minimizes the restriction into the pump and finer grit material will still be filtered by the 10-mircon filter located downstream of the pump before it reaches the injectors.
Where does the fuel filter go in a Holley?
Holley has combined a simple pressure regulator with a filter that allow you to place this regulator just after the fuel pump which will also filter the fuel with its included 10 micron filter. The inlet and outlet are along the long line of the filter while the outlet from the regulator is plumbed as return back to the tank.
How to remove fuel pump and fuel filter?
Remove the fuel pump. Remove the fuel filter (A). When connecting the wire harness, make sure the connection is secure and the terminal (D) is firmly locked into place. When installing the fuel gauge sending unit (E), make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.