What does the error code p1166 stand for?
Error Code P1166 points to a problem in the heater circuit, possibly there is no voltage to the heater, or the heater is bad in the sensor. To diagnose, plug the sensor red pin (pin 2) and blue pin (pin 1) to the heater circuit. On the harness side, there must be 12V within 80 seconds of engine start.
How much does it cost to diagnose Honda code p1166?
The cost to diagnose the P1166 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
When does the ECM set the DTC p1166?
The ECM sets DTC P1166 if no proportional fuel adaptation occurs for a defined time after the lambda controller has reached its minimum or maximum threshold. Need more information on how to fix the P1166 HYUNDAI code?
What does the OBD code p1166 mean?
Error Code P1166 is described as Air/Fuel Ratio Sensor 1 Heater Circuit Malfunction. This means a malfunction is detected in the Air/Fuel (A/F) ratio sensor stemming from an incorrect voltage value registered when the power was drawn to the sensor.
What does engine code p0160 mean?
What the P0160 code means. This code means that the powertrain control module has detected a fault in the circuit for the oxygen sensor for bank 2 sensor 2. The Check Engine Light will illuminate to let the owner know that there is a problem with the emissions system.
What does code p0136 mean?
A P0136 code may indicates that the the powertrain computer or PCM detects that the oxygen sensor voltage has remained below the expected range (in a lean condition, or below 400 millivolts) for too long. This criteria can vary from model to model.
What is the error code for a heater?
Error Code P1166 is described as Air/Fuel Ratio Sensor 1 Heater Circuit Malfunction.
How much does it cost to repair a Honda p1166 code?
The cost of diagnosing the P1166 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Error Code P1166 points to a problem in the heater circuit, possibly there is no voltage to the heater, or the heater is bad in the sensor. To diagnose, plug the sensor red pin (pin 2) and blue pin (pin 1) to the heater circuit. On the harness side, there must be 12V within 80 seconds of engine start.
What does P1167 stand for in EVAP code?
The heater element is on until the engine is at normal operating temp then it switched off. P1167 is the upstream O2 sensor just before the cat. If it is anything like a evap code where the computer has to relearn the sensors parameters under varying load conditions by doing tests etc.
Error Code P1166 is described as Air/Fuel Ratio Sensor 1 Heater Circuit Malfunction.
The cost of diagnosing the P1166 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
The heater element is on until the engine is at normal operating temp then it switched off. P1167 is the upstream O2 sensor just before the cat. If it is anything like a evap code where the computer has to relearn the sensors parameters under varying load conditions by doing tests etc.
What kind of fault is a p1162ho2s11 heater?
P1162HO2S11 Circuit Fault (Bank 1 Sensor 1) P1163HO2S11 Slow Response (Bank 1 Sensor 1) P1164HO2S11 Circuit Fault (Bank 1 Sensor 1) P1165HO2S11 Slow Response(Bank 1 Sensor 1) P1166HO2S11 Heater Circuit Fault (Bank 1 Sensor 1) P1167HO2S11 Heater Circuit (VS+) Fault (Bank 1 Sensor 1)
Where is the primary heater control relay located?
Locate the Primary Heater Control Relay in the passenger under dash fuse box. Pull or backprobe the relay/connector. Pin 30 (red/blue) – pulls power from fuse 6 of the passenger under dash fuse box. Pin 87 (white) – is relay output to the ECM and AFR sensor. Pin 86 (green/red) – is the relay coil control wire from the ECM.
How much does it cost to diagnose a P1167 code?
The cost of diagnosing the P1167 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What was the error code on my Honda Accord?
I used to have both P1166 and P1167 error codes on my 2001 Honda Accord (F23A4 engine). I fixed the P1166 by replacing the O2 sensor. For about a day, everything looked wonderful (i.e. no check engine light on). Then, (after a day), the dreaded check engine light turned on again.