When did the Honda Accord blower motor come out?
How to Replace the Blower Motor in a 1992 Honda Accord. The first Honda Accord was introduced in 1976 as a three-door hatchback. The Accord sedan was not released until 1979. The Honda Accord was the first Japanese car ever to be produced in the United States. The 1992 Honda Accord is equipped with a 2.2-liter, 125-horsepower, four-cylinder engine.
What kind of engine does a 1992 Honda Accord have?
The 1992 Honda Accord is equipped with a 2.2-liter, 125-horsepower, four-cylinder engine. The blower motor in the Honda Accord controls the flow of air through the heating and cooling system of the vehicle. The blower motor is usually removed for replacement or to clean the blower motor’s fan cage.
How to replace the blower bracket on a Honda Accord?
Use 10mm deep socket ratchet and extension to remove the four nuts holding the ECU bracket (which is a large silver plate) in place. There are two nuts on top of the bracket, and there are two nuts on the bottom of the bracket. After removing the nuts, remove the bracket.
Where is the heater duct on a Honda Accord?
The heater duct is located on the left side of the blower motor assembly. Figure 2. Remove self-taping screws holding heater duct in place. Remove the passenger’s side floor mat. Turn over the passenger’s side carpet, and pull it back as far as you can without tearing it.
How to Replace the Blower Motor in a 1992 Honda Accord. The first Honda Accord was introduced in 1976 as a three-door hatchback. The Accord sedan was not released until 1979. The Honda Accord was the first Japanese car ever to be produced in the United States. The 1992 Honda Accord is equipped with a 2.2-liter, 125-horsepower, four-cylinder engine.
The 1992 Honda Accord is equipped with a 2.2-liter, 125-horsepower, four-cylinder engine. The blower motor in the Honda Accord controls the flow of air through the heating and cooling system of the vehicle. The blower motor is usually removed for replacement or to clean the blower motor’s fan cage.
Use 10mm deep socket ratchet and extension to remove the four nuts holding the ECU bracket (which is a large silver plate) in place. There are two nuts on top of the bracket, and there are two nuts on the bottom of the bracket. After removing the nuts, remove the bracket.
The heater duct is located on the left side of the blower motor assembly. Figure 2. Remove self-taping screws holding heater duct in place. Remove the passenger’s side floor mat. Turn over the passenger’s side carpet, and pull it back as far as you can without tearing it.