How does the moonroof work on a Honda Accord?
The AUTO OPEN/CLOSE worked, but after the moonroof stopped closing the rear of the roof would either be tilted slight up (about 1/4″) or too low (about 1/8″). It was getting worse over time where it would close, then tilt up about 1/2″ whereby the rubber seal would expose a gap large enough for water to enter into the cabin.
Why does my Honda sunroof not close properly?
However, many Hondas use a recessed track that easily collects and traps dirt and debris. When this happens, your sunroof may not close and seal properly. Another minor problem is a blown fuse on some model years of Honda vehicles.
Where is the fuse on a Honda sunroof?
Pull the fuse for the sunroof out of the fuse panel using the fuse pullers in the fuse panel. Use the diagram on the underside of the fuse panel cover if you are having trouble locating the fuse for the sunroof. Check the metal strip in the middle of the fuse. The strip should not be burned or damaged.
How do you turn off the engine on a Honda Accord?
Turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode. Press and hold the tilt switch, and turn ignition to ON (II), or press the engine start/stop button to select the ON mode. Release the tilt switch, and turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode.
How do you reset the moonroof on a Honda Accord?
Close the driver’s door, and leave it closed until the procedure is complete. Turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode. Press and hold the tilt switch, and turn ignition to ON (II), or press the engine start/stop button to select the ON mode.
However, many Hondas use a recessed track that easily collects and traps dirt and debris. When this happens, your sunroof may not close and seal properly. Another minor problem is a blown fuse on some model years of Honda vehicles.
Pull the fuse for the sunroof out of the fuse panel using the fuse pullers in the fuse panel. Use the diagram on the underside of the fuse panel cover if you are having trouble locating the fuse for the sunroof. Check the metal strip in the middle of the fuse. The strip should not be burned or damaged.
Turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode. Press and hold the tilt switch, and turn ignition to ON (II), or press the engine start/stop button to select the ON mode. Release the tilt switch, and turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode.