How do you reset the computer on a 2001 Honda Rubicon?
hold both the up and down shift buttons and turn the switch on. then release and press up – down – up , move the throttle lever from fully closed to fully open and then back to fully closed. this all has to be done pretty fast and should here the control motor cycle.
How do you reset a Honda Rincon 650?
Premium Member Press together and hold down the 2 bottom buttons on the left side of you display pod for about 2 or 3 seconds and the light should go off. These are the odometer/tripmeter and clock/hourmeter.
How fast is a Yamaha Grizzly 700?
The top speed of a stock Yamaha Grizzly 700 is 64 mph.
What’s the problem with my Honda Rubicon 500?
I have a 2006 Honda rubicon TRX500 FA/FGA with GPScape It wont shift out of 1 st gear either in D1 , D2 or ESP the shift display blinks 6 times….when I go in reverse the motor sputters / misses…never stops but obviously not normal… Jaak: Download a service manual below.
Can a 2001 Honda Rubicon go in drive?
2001 Honda rubicon wont go in drive! For a while you could 2001 Honda rubicon wont go in drive! For a while you could move the shift back and forth it would eventually go into drive. Now nothing! I replaced the … read more
Can a Honda Rubicon 500 shift over 3 Gears?
D1 or D2 position it doesn’t shift over 3 gear, but ESP works well. Diagnostic shows code 6, angle sensor. I measured the sensor and it is fine, as well as shift motor. I deleted the code, but it doesn’t give a new one. Where is the problem? Jaak: Welcome to the forum.
Is there a Honda TRX 500 repair manual?
All download manuals cover every aspect of ATV repair, from complete engine overhaul to basic TRX500 maintenance, and includes troubleshooting information for diagnosing critical problems. The 2001-2011 Honda TRX 500 four wheeler repair manuals are in pdf format, no special software is needed to download and view a manual.
2001 Honda rubicon wont go in drive! For a while you could 2001 Honda rubicon wont go in drive! For a while you could move the shift back and forth it would eventually go into drive. Now nothing! I replaced the … read more
How to change shift on Honda Rubicon 500?
Push and hold the UP and DOWN shift switches simultaneously for 3 seconds of more while the problem code is being displayed (i.e., “ – – “ blinking on the gear position indictor). 2. When the erasure is completed, the blinking pattern changes to the erasure confirmation blink.
What kind of gear positioning switch does a Honda Rubicon have?
TO FIX THIS I CAN’T SEEM TO FIND THE PART. FOR: 1997 HONDA 500cc RUBICON IS A GEAR POSITIONING SWITCH IT HAS 3 PRONGS INPUT, I FOUND A 4 PRONG FOR A 2001 , CAN’T FIND MY YEAR ANY … read more
What to do if your Honda trx500fa reverses?
Put the gear shift lever in neutral (be sure the neutral indicator comes on) and the ignition switch OFF (vehicle at a stop). 2. While pushing the UP and DOWN shift switches (ESP) simultaneously, turn the ignition key to the on position.