Where is the ignition timing on a Honda Civic DX?
Honda recommends that the ignition timing be checked every 60,000 miles (96,500 km) and adjusted (if necessary). On all Civic series engines the timing marks are located on the crankshaft pulley, with a pointer on the timing belt cover. All are visible while looking at the driver’s side of the engine compartment.
Do you need a timing light for a Honda Civic?
This article applies to the Honda Civic (1990-2000). In order to keep your Honda running great, the ignition timing has to be set properly. Symptoms of poorly-set timing include engine pinging, running rich, or running lean. To successfully get this job done you will need a timing light. You can purchase or borrow one.
What happens when you advance the ignition timing?
When you advance your ignition timing, you’re beginning the lighting of the air/fuel mixture earlier during the compression stroke in the combustion chamber. Once you’re done, tighten the top distributor cap bolt to secure its position. I n-depth Write Up – Superhonda.com
Where is the service connector on a Honda Civic?
The service connector is located on the passenger side. It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it.
How do you adjust ignition timing on a Honda Civic?
After you have the service connector properly jumped, you can now turn on your car and start the actual reading and adjusting. First, loosen the three small bolts around the distributor cap in case you end up having to retard or advance the timing. Under the hood there should be a label that gives you the timing requirements.
Where is the ignition button on a Honda Civic?
It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it. You want to do this so the computer doesn’t try adjusting after you do your own adjustments.
When you advance your ignition timing, you’re beginning the lighting of the air/fuel mixture earlier during the compression stroke in the combustion chamber. Once you’re done, tighten the top distributor cap bolt to secure its position. I n-depth Write Up – Superhonda.com
The service connector is located on the passenger side. It is underneath the glove box by the kick panel. It’s the same connector used to read check engine lights. You need to disconnect it and put a small wire connecting both sides of the connector in order to short it.