How do you reset a GE washing machine?
Unplug the washer for one minute, then plug the washer back into the electrical outlet and lift and lower the lid six times within 12 seconds. This will reset the motor and you should be able to start the cycle.
How do you troubleshoot a GE washing machine?
How to Troubleshoot a GE Top Load Washer
- Check the amount of detergent you have put in the washer.
- Examine the GE top load washer’s drain hose for leaks.
- Check the water connections to your GE top load washer.
- Check whether the GE top load washer lid is closing firmly.
- Check the load in your GE top loading washer.
Why does my GE washing machine stop mid cycle?
Common solutions for: GE Washer stops mid cycle If the washer door is not latched shut, the door switch prevents the washer from operating. If the door lock is defective, the washer may stop mid cycle. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
Why is my GE washer not filling up all the way?
Machine Won’t Fill If your washer won’t fill, check the hot and cold faucets to make sure they’re both turned on fully. Check the fill hoses, which connect to the upper back left of most GE washers, and make sure the line has no kinks. If the problem persists, turn off the water and remove the fill hoses.
Why is my GE washer not draining or spinning?
If the washer drains properly, then the clog has likely cleared. If water remains in the washer, check for a pinched or flattened drain hose. If you clear a clog, press START to resume your cycle or you can select Drain & Spin and press Start. If the water drains, then the clog is clear.
What causes the washing machine to stop from working?
There are a few possible reasons for this: – The locking mechanism could have jammed (maybe some clothes have gotten in the way). – There could be a glitch in the washer’s computer. – The washing machine may not be draining properly, leaving the washer door locked and the drum filled with water.
How do you reset the code on a GE washing machine?
How to Access Error Codes on GE Washers
- Press the “Power” button on your GE washer.
- Unplug the power cord for at least 30 seconds.
- Plug the power cord back in to the GE washer.
- Press “Delay Start” to advance to “t02”.
- Press and hold “Start/Pause” to clear the saved error codes after viewing them.