How to set timing on 1998 Chevy truck 350 Vortec?
There is a “Cam ******” that is, but a scanner is needed to adjust it. Its basically lining up the rotor to the dist cap. You can’t post conmments that contain an email address. An expert who has achieved level 1. An expert that has 1 follower.
What is signal wire on GMC Suburban 5.7?
The signal wire goes from 0.51 volts at an idle to 4.56 volts at wide open throttle. Oil pressure sensor tan middle wire shows a good ground. Grey wire show 8.75 volts and the red wire shows 12.37 volts. If I jump the two end wires together the fuel pump runs constantly however, this time is wont start.
How many volts does a GMC Suburban have?
0.51 volts on the signal wire, a good ground and the power wire shows 5.07 volts. The signal wire goes from 0.51 volts at an idle to 4.56 volts at wide open throttle.
What is coolant temp on GMC Suburban 5.7?
Sensor maintained the 1.15 psi for over 2 minutes and the voltage went up to 1.17 towards the middle of two minutes, however the voltage never dropped until I released the pressure. Coolant temperature sensor showed… approximately 2.5 ohms at room temperature and went down to 0.21 ohms in 190 degree boiling water.
There is a “Cam ******” that is, but a scanner is needed to adjust it. Its basically lining up the rotor to the dist cap. You can’t post conmments that contain an email address. An expert who has achieved level 1. An expert that has 1 follower.
How to set timing on a 1994 Chevy 1500 truck with?
Chevy Technician Vocational, Technical or Trade Scho 9,659 satisfied customers 94 chevy k1500 4×4 pickup wont pass emissions. Had it diagnosed 94 chevy k1500 4×4 pickup won’t pass emissions. Had it diagnosed and was told that it needs to have the valve cover gaskets replaced and a new intake manifold set.
How many miles does a 1994 Chevy 1500 have?
Chevrolet Silverado 1500 Classic LS: 1994 chevy truck 350 cid 1994 chevy truck 350 cid with tbi. 62000 miles. Truck run perfect when cold but after it warms up it backfires though the intake bad and has no power. It almost impossible to drive. I did basic tune u… read more Gary Chevy Technician Vocational, Technical or Trade Scho
Where does the distributor Go in a Chevy 5.7?
Insert the distributor into the engine, facing the rotor about 10 degrees to the right of the mark on the block. Slide it into the block. When the gears mesh, the rotor should turn and line up with the lines on the distributor and the engine.